Removal Procedure
Show/hide table
Table 1
Required Tools     |
Tool     |
Part Number     |
Part Description     |
Qty     |
A     |
8S-8048     |
Saddles     |
2     |
8S-7630 |
Stands     |
2     |
8S-7625 |
Collars     |
2     |
8S-7641 |
Tubes     |
2     |
8S-7650 |
Cylinder Assemblies     |
2     |
4C-5809 |
Electric Hydraulic Pump Gp     |
1     |
B     |
9U-7536     |
Lift Stand     |
2     |
4C-5809 |
Electric Hydraulic Pump Gp     |
1     |
C     |
8S-7640     |
Stand     |
1     |
8S-7631 |
Tube     |
1     |
FT1603 |
Tube Cap     |
1     |
D     |
1U-9200     |
Lever Puller Hoist     |
1     |
138-7574 |
Link Bracket     |
1     |
Start By:
- Release the hydraulic system pressure. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release".
Show/hide table
|
NOTICE |
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
|
Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
Show/hide table
|
|
|
Illustration 1 | g01083087 |
- Use Tooling (A) in order to support draft frame (1) .
Show/hide table
|
|
|
Illustration 2 | g01083090 |
- Use Tooling (B) in order to support the tractor.
Show/hide table
|
|
|
Illustration 3 | g01083080 |
- Remove guards (2) .
Show/hide table
|
|
|
Illustration 4 | g01083086 |
- Remove clamps (3) .
Show/hide table
|
|
|
Illustration 5 | g01083085 |
- Disconnect hose assemblies (4) .
Show/hide table
|
|
|
Illustration 6 | g01083098 |
Show/hide table
|
|
|
Illustration 7 | g01083100 |
- Install a suitable lifting device to arm assembly (6). Support arm assembly (6) with Tooling (C). Remove bolts (5).
Show/hide table
|
|
|
Illustration 8 | g01083103 |
- Install Tooling (D) to arm assembly (6). Remove Tooling (C) and lower arm assembly (6) .
Show/hide table
|
|
|
Illustration 9 | g01083104 |
- Remove bolts (8). Remove guard (7) and cap (9). The weight of arm assembly (6) is approximately 770 kg (1700 lb). Remove arm assembly (6) .