Stator - Test
Show/hide table
Illustration 1 | g01066106 |
(6) Stator (7) Stator leads (8) Stator frame |
Stator Winding Continuity Test
- Connect the multimeter leads between each combination of two stator leads (7) : (A to B), (B to C) and (C to A). Make a note of each measurement.
- The three measurements should be approximately 0.063 ohms.
- Replace the stator (6) if any of the measurements are incorrect. If a measurement is too low, the stator (6) is shorted. If a measurement is too high, the stator (6) is open.
Stator Winding Ground Test
- Set the multimeter to the 20 M ohm resistance scale. Measure the resistance between each stator lead (7) and the stator frame (8) : (A to 8), (B to 8) and (C to 8) .
- Each measurement should be greater than 100 K Ohms (0.100 M Ohms).
- If any of the three measurements are low, the stator (6) is shorted to the stator frame (8). Replace the stator if a short is measured.
Caterpillar Information System:
SCJ and 8SC Series Alternators Field Winding - Test
906 and 908 Wheel Loaders Hydraulic and Steering System Fan and Coupler Hydraulic System
SCJ and 8SC Series Alternators Capacitor - Test
902, 906 and 908 Compact Wheel Loaders Maintenance Interval Schedule - 906 and 908 Compact Wheel Loaders
2004/03/22 New Thrust Discs Improve the Service Life of the Planetary Carriers and the Planetary Gear Mills {3030}
902, 906 and 908 Compact Wheel Loaders Maintenance Interval Schedule - 902 Compact Wheel Loaders
AD45B Underground Articulated Truck Power Train Output Transfer Gears - Assemble
AD45B Underground Articulated Truck Power Train Output Transfer Gears - Disassemble
2004/05/10 New Test ECM Available for Machines {0785, 7610}
Product Link PL-102C System Installation{7606} Product Link PL-102C System Installation{7606}
992G Wheel Loader and 854G Wheel Dozer Power Train Position Sensor (Left Brake Pedal) (Electronic Technician) - Calibrate
992G Wheel Loader and 854G Wheel Dozer Power Train Engagement Pressure for the Lockup Clutch of the Torque Converter (Electronic Technician) - Calibrate
Installation of New Operator Control Joysticks{4122} Installation of New Operator Control Joysticks{4122}
906 and 908 Wheel Loaders Hydraulic and Steering System Work Tool Hydraulic System
D11R Track-Type Tractor Daily Inspection
3408E and 3412E Engines for Caterpillar Built Machines Flash Programming
D11R Track-Type Tractor Bulldozer Blade Control
3516B and 3516B High Displacement Engines for 994D and 994F Wheel Loaders Accessory Drive (Upper Left Hand)
988G Wheel Loader Power Train Torque Converter (Lockup) - Disassemble
950G Series II Wheel Loader System Components
988G Wheel Loader Power Train Torque Converter (Lockup) - Assemble
D10R Track-Type Tractor Engine Starting with Prelubrication System
D11R Track-Type Tractor Operation Information
Dimensions for the 994 Wheel Loader Hitch{7051, 7054, 7057, 7100} Dimensions for the 994 Wheel Loader Hitch{7051, 7054, 7057, 7100}