Cylinder Liner - Install
Installation Procedure
Show/hide table
Required Tools     | |||
---|---|---|---|
Tool     | Part Number     | Part Description     | Qty     |
B     | 2P-8260     | Cylinder Liner Installer     | 1     |
C     | 5P-3975     | Rubber Lubricant     | 1     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Check the cylinder liner projection. Refer to Testing and Adjusting, "Cylinder Liner Projection - Inspect".
- Install liner seals (3) in the respective grooves.
Show/hide table
Illustration 1 | g01004993 |
- Apply Tooling (C) on the cylinder block liner bore surfaces and liner seals (3) .
- Dip filler band (2) in clean engine oil for a moment. Install filler band (2) and install cylinder liner (1) immediately.
- Use Tooling (B) to install cylinder liner (1) in the cylinder block. Ensure that any marks in relation to the cylinder liner projection are in alignment.
Note: Refer to Special Instruction, SEHS9564 for more information about cylinder liner installation.
Show/hide table
Illustration 2 | g01005003 |
End By: Install the pistons and connecting rods. Refer to Disassembly and Assembly, "Pistons and Connecting Rods - Install".
Caterpillar Information System:
3126B Generator Set Engine Engine Temperature Sensor Open or Short Circuit - Test
3412E Petroleum Engine Engine Oil Pan - Remove and Install
TH48-E80 Petroleum Transmission Power Train Electronic Control System Position Sensor (Transmission Gear) - Check
770 and 772 Off-Highway Truck Chassis Electronic Control System Starting System
3126B Generator Set Engine Engine Pressure Sensor Open or Short Circuit - Test
TH48-E80 Petroleum Transmission Power Train Electronic Control System Diagnostic Code List
TH48-E80 Petroleum Transmission Power Train Electronic Control System Diagnostic Capabilities
C13, C15, and C18 Tier 4 Final Engines Electric Starting Motor
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines Fuel Rail Pump Solenoid - Test
TH48-E80 Petroleum Transmission Power Train Electronic Control System Electrical Component and Connector Locations
Caterpillar On-Highway Diesel Engine Fluids Recommendations Characteristics of Diesel Fuel
2005/08/15 An Improved Idler Pulley Has Been Released {1358}
3608 Engine Crankshaft Position for Fuel Timing and Valve Lash Adjustment
3406C Engines for Caterpillar Built Machines Engine Oil Pump
3412E Petroleum Engine Piston Cooling Jets - Remove and Install
C280 Marine Engines Metal Particle Detector
C280 Marine Engines Metal Particle Detector - Test
C9-XQ300 Rental Generator Set Wiring Diagrams
3412E Petroleum Engine Pistons and Connecting Rods - Disassemble
3512C SR4B Generator Sets Product Description
C280 Marine Engines Internal Lubrication
2005/11/21 A New Connecting Rod is Used in 3500B and 3500C High Displacement Machine Engines {1218}
3412E Petroleum Engine Pistons and Connecting Rods - Assemble
3500 Generator Sets Product Lifting