3126B Petroleum Engine Caterpillar


Inlet Air Temperature Sensor - Remove and Install

Usage:

3126B Z2A

Removal Procedure


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.





    Illustration 1g01184624

  1. Disconnect the harness assembly from inlet air temperature sensor (1) .

  1. Remove inlet air temperature sensor (1) .

  1. Inspect the condition of the O-ring seal on inlet air temperature sensor (1). Replace the O-ring seal, if necessary.

Installation Procedure


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.





    Illustration 2g01184624

  1. Install inlet air temperature sensor (1). Tighten inlet air temperature sensor (1) to a torque of 20 ± 5 N·m (15 ± 4 lb ft).

  1. Connect the harness assembly to inlet air temperature sensor (1) .

Caterpillar Information System:

Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.