Oil Temperature Gauges Must Be Used With The Correct Senders{7488,7489}
Usage:
All Models With Electric Oil Temperature Gauges
Care must be taken when service is performed on oil temperature gauges and oil temperature senders. Oil temperature gauges and senders are calibrated for use in certain combinations. If a gauge or sender is replaced, check the parts book to make sure that only the correct gauge and sender combination is used.
Show/hide table
| NOTICE |
|---|
The gauge and sender calibrations are not marked on the parts. An incorrect gauge and sender combination can cause a wrong temperature reading. This could cause a component failure.
|
Caterpillar Information System:
1984/06/11 Higher Gloss Paint Used On Caterpillar Products{7559,0374}
1984/06/11 Changes Made To Air Shutoff And Rack Shutoff Groups{1078,7418}
1984/06/11 New Air Start And Override Valve Has Stronger Mounting{1451}
1984/06/04 New Bearing Race Is Used On The Auxiliary Drive{1359}
1984/06/04 Excessive Oil Consumption: Check The Accuracy Of The Oil Level Gauge{1302,1316,1318}
1984/06/04 Remanufactured Oil Pumps Available{1304}
1984/06/04 New Color Used For Fan Belt Tightener Spring{1358}
1984/06/04 Information Concerning Caterpillar XT Hose{7554}
1984/06/04 FT1818 Track Link Grinding Stand And FT1844 Track Pin Grinding Attachment Available{0664,0665,4169,4171,4174,4175}
1984/06/04 Salvaging Cylinder Block Top Decks After Liner Seat Erosion{1201,1216,1217}
1984/06/04 Drain Line Added To Reduce Pressure In BrakeSaver Housing{1155}
1984/06/04 Reusability Of Brake Pads{4273,4255}
1984/06/11 Valve Springs Must Be Removed Before Fuel Injection Nozzle Adapter Assembly Is Removed{1106}
1984/06/25 Copper Seals Available For JIC (Joint Industry Conference) Fittings {0600,0683,0684}
1984/06/25 New Ammeter And Ammeter Calibrator Group Available {0651}
1984/06/25 MG507 Marine Transmission Uses Metric Fasteners {3354}
1984/06/25 Oil Recommendations For Power Shift Transmissions {3179}
1984/06/25 New Cylinder Head Has Larger Mounting Holes For The Lifting Brackets {1100,1101}
1984/06/25 New Rear Crankshaft Seal Group Used {1161}
1984/07/02 Procedure To Clean Oil Passages In Crankshafts And Cylinder Blocks{0622,0675,1201,1202}
1984/07/02 Modification To FT1488 Exciter Tester Group Allows Testing Of All Small Frame SR4 Generators{0785,4450,4467}
1984/07/02 New Crankshaft, Cylinder Block And Camshaft Used{1202,1201,1210}
1984/07/02 Surface Grinding Of Compacted Graphite Iron Cylinder Heads{1101}
1984/07/09 New Disassembly And Assembly Tools Available For Fuel Ratio Controls{0600,1278}