Engine Oil Cooler - Remove
- Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Show/hide table
Illustration 1 g01182581 - Disconnect tube assembly (4).
- Remove bolts (1) and washers (2).
- Remove bolts (3) and bonnet (5).
- Remove bolt (6). Remove bolts (7) and washers (8).
- Lower oil tube assembly (9).
Show/hide table
Illustration 2 g01182599 - Disconnect tube assembly (12).
- Remove bolts (10). Remove bolt (14), the washer, and the spacer.
- Remove bonnet (13).
- Remove bolts (15) from the engine oil cooler (11). Remove engine oil cooler (11).
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Caterpillar Information System:
3500 Engines with EUI Option Engine Design
3500 Engines with EUI Option Engine Design
3500 Engines with EUI Option Engine Design
C7 and C9 On-Highway Engines Engine Speed - Test
C6.6 Engines for Caterpillar Built Machines Crankshaft
C32 Marine and Auxiliary Marine Engines Engine Oil Filter Base - Install
C32 Marine and Auxiliary Marine Engines Engine Oil Filter Base - Assemble
3126B Petroleum Engine Flywheel - Remove and Install
3126B Petroleum Engine Water Temperature Regulator - Remove and Install
C32 Marine and Auxiliary Marine Engines Engine Oil Filter Base - Disassemble
C18 Petroleum Generator Sets Generator Lead Connections
3126B Petroleum Engine Water Temperature Regulator Housing - Remove and Install
C7 and C9 On-Highway Engines Turbocharger - Test
Installation Procedure for the Gasket and Front Plate of the 3456 Engine{1151} Installation Procedure for the Gasket and Front Plate of the 3456 Engine{1151}
TH48-E80 Petroleum Transmission Torque Converter Housing
C7 and C9 On-highway Engines Engine Oil Level - Check
C32 Marine and Auxiliary Marine Engines Engine Oil Cooler - Install
2005/07/04 New Software Reduces the Trip Points on the Fuel Pressure Sensor {1718, 7620}
2005/07/01 An Improved Idler Pulley Has Been Released {1358}
2005/07/04 An Improved Idler Pulley Has Been Released {1358}
C7 and C9 On-Highway Engines Intake Manifold Air Temperature Is High
3126B Petroleum Engine Water Pump - Disassemble
3126B Petroleum Engine Water Pump - Assemble
C9 Generator Set Fuel System Primary Filter/Water Separator - Drain