Engine Oil Filter Base - Assemble
- Lubricate valve (8). Install valve (8) in oil filter base assembly (7).
- Lubricate plunger (6) and spring (5) with clean engine oil. Install plunger (6) and spring (5) in oil filter base assembly (7).
- Position gasket (4) and cover (3) on oil filter base assembly (7). Install bolts (1) and washers (2).
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
Illustration 1 | g01182356 |
Show/hide table
Improper assembly of parts that are spring loaded can cause bodily injury. To prevent possible injury, follow the established assembly procedure and wear protective equipment. |
End By:
- Install the engine oil filter base. Refer to Disassembly and Assembly, "Engine Oil Filter Base - Install".
Caterpillar Information System:
3126B Petroleum Engine Flywheel - Remove and Install
3126B Petroleum Engine Water Temperature Regulator - Remove and Install
C32 Marine and Auxiliary Marine Engines Engine Oil Filter Base - Disassemble
C18 Petroleum Generator Sets Generator Lead Connections
3126B Petroleum Engine Water Temperature Regulator Housing - Remove and Install
C7.1 (Mech) Industrial Engine Gear Group (Front)
Caterpillar 270 Air Compressor Discharge Valve Leakage - Test
Caterpillar 270 Air Compressor Air Compressor Governor - Test and Adjust
Caterpillar 270 Air Compressor Excessive Oil at Exhaust Ports or Air Strainer
Caterpillar 270 Air Compressor Excessive Build-Up and Recover Time
C7.1 (Mech) Industrial Engine Oil Pump
C9 Generator Set Engine Crankcase Breather - Clean
C32 Marine and Auxiliary Marine Engines Engine Oil Filter Base - Install
C6.6 Engines for Caterpillar Built Machines Crankshaft
C7 and C9 On-Highway Engines Engine Speed - Test
3500 Engines with EUI Option Engine Design
3500 Engines with EUI Option Engine Design
3500 Engines with EUI Option Engine Design
C32 Marine and Auxiliary Marine Engines Engine Oil Cooler - Remove
C7 and C9 On-Highway Engines Turbocharger - Test
Installation Procedure for the Gasket and Front Plate of the 3456 Engine{1151} Installation Procedure for the Gasket and Front Plate of the 3456 Engine{1151}
TH48-E80 Petroleum Transmission Torque Converter Housing
C7 and C9 On-highway Engines Engine Oil Level - Check
C32 Marine and Auxiliary Marine Engines Engine Oil Cooler - Install