Water Pump - Test
Show/hide table
所需工具     | ||
零件号     | 零件名称     | 数量     |
6V-7775     | 气压表     | 1     |
8J-7844     | 适配器接头     | 1     |
3K-0360     | O 形密封圈     | 1     |
5P-2725     | 探头密封件适配器     | 1     |
164-2192     | 压力探头 (1)     | 1     |
5P-4487     | 适配器     | 1     |
5P-2720     | 探头适配器总成     | 1     |
Show/hide table
( 1 ) | 如果使用端口 (1) ,则需要两个工具。 |
Show/hide table
图 1 | g01524965 |
水泵的压力测试端口 (1) 端口(备用加热器供应) (2) 端口(发动机诊断) (3) 端口(加热器回流管) |
Show/hide table
接触正在运转的发动机会因热零件而导致灼伤或因旋转零件而导致伤害。 在旋转的发动机上工作时,避免接触热零件或旋转零件。 |
压力升高量就是进口和出口之间的差值。 通过压力升高量可判断水泵是否工作正常。 端口 (1) 和端口 (2) 代表水泵出口压力。 端口 (3) 代表水泵进口压力。
通过对比进口压力和出口压力即可测得压力升高量。 计算进口和出口间的压差。 在以下两种情况下,必须在压力升高量上加上最少 80 kPa (12 psi):
- 发动机处于工作温度。
- 发动机在满载工况下运转。
Caterpillar Information System:
Yellowmark Noise and Roading Homologation Statement {1062} Yellowmark Noise and Roading Homologation Statement {1062}
C9 Engine for Caterpillar Built Machines Fuel Filter Base - Remove and Install
C7 On-highway Engine Cooling System
3500B and 3500C Generator Set Engines MID 036 - CID 0175 - FMI 03 Engine Oil Temperature open/short to +batt
3500B and 3500C Generator Set Engines MID 036 - CID 0799 - FMI 12 Need Service tool update
3500B and 3500C Generator Set Engines MID 036 - CID 0175 - FMI 04 Engine Oil Temperature short to ground
C4.4 Marine Generator Set Engines Electric Starting Motor - Remove and Install
C4.4 Marine Generator Set Engines Electric Starting Motor - Remove and Install
C4.4 Marine Generator Set Engines Fuel Filter Base - Remove and Install
C4.4 Marine Generator Set Engines Speed/Timing Sensor - Remove and Install
C9 Engine for Caterpillar Built Machines Fuel Priming Pump - Remove and Install
3500B and 3500C Generator Set Engines Diagnostic Codes
2005/05/16 New 3500 Marine Propulsion Software Available {7620}
C4.4 Marine Generator Set Engines Aftercooler - Remove and Install
C280 Marine Auxiliary Engines Too Much Vibration
2005/05/01 New Full Load Settings and New Full Torque Settings are Now Available {7620}
C9.3 Tier 4 Final Engines Finding Top Center Position for No. 1 Piston
C27 and C32 Industrial and Petroleum Engines Coolant Level Sensor Circuit - Test
C7 On-highway Engine Turbocharger - Inspect
3500B and 3500C Generator Set Engines Electrical Connectors and Functions
2005/05/16 A New Aftercooler Core is Used {1063, 1064}
C9.3 Engines for Caterpillar Built Machines Vibration Damper - Check
C27 and C32 Industrial and Petroleum Engines Electrical Power Supply Circuit - Test
2005/05/23 A New Gasket is Used {1063, 1380}