Cylinder Block
Show/hide table
Illustration 1 | g00904878 |
(1) Bore in the cylinder block
- Diameter of the bore in the cylinder block ...
84.000 to 84.019 mm (3.3071 to 3.3078 inch)
- Service limit ...
84.200 mm (3.3150 inch)
Show/hide table
Illustration 2 | g00901145 |
Flatness of the top of the cylinder block ... Less than 0.05 mm (0.002 inch)
Service limit ...
Note: Use a straight edge and a feeler gauge to check the six positions for flatness.
Note: The front crankshaft bearing must be installed with the chamfer toward the cylinder block. Ensure that the oil hole in the front crankshaft bearing is aligned with the oil hole in the cylinder block.
Caterpillar Information System:
C7 On-highway Engine Cylinder Head
C2.2 Engine and C1.5 Generator Set Water Temperature Regulator
C2.2 Engine and C1.5 Generator Set Engine Oil Relief Valve
C4.4 Marine Auxiliary Generator Set Engine Heater Mounting Group - If Equipped
C2.2 Engine and C1.5 Generator Set Camshaft
C2.2 Engine and C1.5 Generator Set Exhaust Manifold
C2.2 Engine and C1.5 Generator Set Cylinder Head
C2.2 Engine and C1.5 Generator Set Cylinder Head Valves
C2.2 Engine and C1.5 Generator Set Valve Mechanism Cover
C2.2 Engine and C1.5 Generator Set Rocker Shaft
C2.2 Engine and C1.5 Generator Set Lifter Group
C2.2 Engine and C1.5 Generator Set Fuel Injection Nozzles
C2.2 Engine and C1.5 Generator Set Crankshaft
C2.2 Engine and C1.5 Generator Set Connecting Rod Bearing Journal
C2.2 Engine and C1.5 Generator Set Main Bearing Journal
C2.2 Engine and C1.5 Generator Set Engine Design
C2.2 Engine and C1.5 Generator Set Connecting Rod
C9 Generator Set Self-Diagnostics - If Equipped with EMCP 3
C2.2 Engine and C1.5 Generator Set Piston and Rings
C2.2 Engine and C1.5 Generator Set General Information
C2.2 Engine and C1.5 Generator Set Gear Group (Front)
3500 Engines Crankcase Pressure (High)
3500 Engines Coolant Temperature Is Too Low
3500 Engines Engine Overspeed