Air Conditioning and Heating System Sensor Operation
水温传感器
Show/hide table
图 1 | g00468069 |
水温传感器用来检测流入加热器芯的发动机冷却液温度。 传感器随后向控制模块发回信号。 此传感器位于加热器芯的后侧。
空气温度传感器(再循环空气)
Show/hide table
图 2 | g00468147 |
此传感器用来检测驾驶室内的温度。 传感器随后向控制模块发回信号。 此传感器位于再循环空气的入口。
蒸发器(霜冻)传感器
Show/hide table
图 3 | g01130938 |
(R) 电阻(Ω) (T) 温度 °C(°F) |
蒸发器(霜冻)传感器是一种半导体。 温度升高时,电阻降低。 相反,当温度降低时,电阻升高。
蒸发器(霜冻)传感器位于蒸发器 (8) 的出口侧。 蒸发器(霜冻)传感器用来检测从蒸发器 (13) 时经过冷却空气的温度。 传感器随后向控制面板内的放大器发回信号。
当温度低于 3°C (37°F) 时,控制面板将空调离合器接合。 空气温度大于等于 4°C (39°F) 时,空调离合器接合。 此传感器还可防止蒸发器冻结。
继电器开关
Show/hide table
图 4 | g01130997 |
此继电器开关用来接合空调离合器。 此继电器还用来分离空调离合器。
HI 风扇转速也受这种继电器的控制。
参考关于这两个继电器的位置,请参阅示意图, "空调电气系统"。
Caterpillar Information System:
G3612 and G3616 Engines Specifications
3500 Engines Prelubrication Oil Pump - Remove and Install
3508B, 3512B and 3516B Generator Set Engines Electric Starting Motor - Remove and Install
G3612 and G3616 Engines Connecting Rod Bearings - Inspect/Replace
VR6B Voltage Regulator Installation For 480V Sensing VR3 Regulators On 3500 Generator Sets {4467} VR6B Voltage Regulator Installation For 480V Sensing VR3 Regulators On 3500 Generator Sets {4467}
C9 Engines for Caterpillar Built Machines Aftercooler - Test
3508C, 3512C and 3516C Marine Engines Electronic Unit Injector - Install
3508C, 3512C and 3516C Marine Engines Electronic Unit Injector - Remove
345C MHPU Mobile Hydraulic Power Unit Radiator Core - Clean
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Crankshaft Rear Seal - Install
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
C0.5, C0.7, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines After Stopping Engine
C32 Marine Engines CAN Data Link Circuit - Test
G3606 and G3608 Engines Specifications
2009/06/08 The 164-5585 Aftercooler Core As Is Now Nonserviceable {1063, 1064}
307D, 311D, 312D, 313D, 315D, 318D, 319D, 320D, 323D, 324D, 325D, 326D, 328D, 329D, 330D, 336D, 340D, 345D, 349D, 374D, 390D and M325D Excavators Air Conditioning and Heating Speed Control
C32 Marine Engines Cat Data Link Circuit - Test
C0.5, C0.7, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Plate Locations and Film Locations
C0.5, C0.7, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Emissions Certification Film
C0.5, C0.7, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Electrical System
C-10, C-12, C-15 and C-16 Industrial Engines Engine Speed/Timing Sensor - Calibrate
2005/03/01 An Improved Exhaust Sleeve Assembly is Now Used on Certain On-Highway Engines {1059, 1100}
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Troubleshooting
Replacing the MIDS Display with an Advisor M2 Display{7490} Replacing the MIDS Display with an Advisor M2 Display{7490}