Piston Pump Oil Leakage (Secondary Steering) - Test
This test is designed to tell if the secondary steering pump is operating within the design parameters.
Perform this test on a hydraulic test bench. Prior to the test, the hydraulic oil must be at 65° ± 2°C (149° ± 4°F). Refer to Table 1 for more information.
Show/hide table
Oil Leakage Test     | |||
Pump Speed     | Approximate Oil Pressure     | Pump Output     | Oil Leakage     |
2000 rpm     | 6900 kPa (1000 psi)     |
73.0 L/min (19.3 US gpm)     |
7.1 L/min (1.9 US gpm)     |
2000 rpm     | 10300 kPa (1500 psi)     |
72.8 L/min (19.2 US gpm)     |
8.0 L/min (2.1 US gpm)     |
2000 rpm     | 13800 kPa (2000 psi)     |
72.0 L/min (19.0 US gpm)     |
8.3 L/min (2.4 US gpm)     |
2000 rpm     | 17250 kPa (2500 psi)     |
71.0 L/min (18.7 US gpm)     |
10.4 L/min (2.7 US gpm)     |
If the amount of oil leakage is greater than the amount that is specified in Table 1, the pump is worn.
Caterpillar Information System:
3408E and 3412E Engines for Caterpillar Built Machines Crankshaft - Install
545 Wheel Skidder Power Train Electronic Control Module (Power Train) - Remove and Install
3034 Engine for Caterpillar Built Machines Engine Oil Filter Base - Install
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Exhaust Manifold - Remove and Install
D8R Series II Track-Type Tractor General Torque Information
994D Wheel Loader Machine System Piston Pump (Brake) - Disassemble
994D Wheel Loader Machine System Lift Cylinder - Assemble
992G, 992K, 994, 994D and 994F Wheel Loaders VIMS Loader Payload System Onboard Menu Operation
994D Wheel Loader Machine System Tilt Cylinder - Assemble
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Flywheel Housing - Remove and Install
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Engine - Clean
3500B Engines Accessory Drive (Upper Right Hand)
3056 Engines Engine Oil Cooler Bypass Valve
994D Wheel Loader Power Train Pump Drive (Front) - Remove
D8R Track-Type Tractor Cooling System (DEAC) Additive - Add
3054 and 3056 Industrial and Generator Set Engines Water Temperature Regulator Housing
613C Series II Wheel Tractor-Scraper Ejector Carrier Rollers - Check/Adjust
3408E and 3412E Engines for Caterpillar Built Machines Flywheel Housing - Remove and Install
545 Wheel Skidder Fuel Tank Water and Sediment - Drain
611 and 615C Series II Wheel Tractor-Scrapers Steering System Steering Time - Check
545 Wheel Skidder Engine Supplement Refrigerant Condenser - Remove and Install
545 Wheel Skidder Power Train Transmission Oil Filter - Remove and Install
D9R Track-Type Tractor Transmission Control
3034 Engine for Caterpillar Built Machines Water Pump - Remove