Removal Procedure
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 6V-0113     | Cylinder     | 1     |
9U-6751 | Sleeve     | 1     | |
4C-9634 | Puller Stud     | 1     | |
1U-6150 | Plate     | 1     | |
5P-8712 | Bushing     | 1     | |
9U-6753 | Retainer Plate     | 1     | |
9U-6832 | Nut     | 1     | |
9R-3971 | Rod     | 4     | |
4T-4133 | Nut     | 4     | |
8T-4121 | Washer     | 4     | |
6V-5192 | Bolt     | 3     | |
3S-6224 | Pump     | 1     | |
B     | 138-7574     | Link Bracket     | 1     |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes to prevent fluid loss and to keep contaminants from entering the system.
- Install Tooling (B) to guard assembly (1) and attach a suitable lifting device, as shown.
Illustration 1 | g00560979 |
- Remove bolts (2) and remove guard assembly (1) . The weight of the guard assembly is approximately 34 kg (75 lb).
- Remove hydraulic hose assemblies (3) for the tilt cylinder.
Illustration 2 | g00535506 |
- Attach a suitable lifting device and a hoist to the tilt cylinder, as shown. Use Tooling (A) and remove pins (4) and (5) .
Illustration 3 | g00535508 |
Illustration 4 | g00535509 |
- Remove the tilt cylinder. The weight of the tilt cylinder is approximately 860 kg (1896 lb).