Removal Procedure
Tools Needed     | A     | B     |
8S-7640 Stand     | 2     | |
138-7575 Link Bracket     | 2     |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Note: Drain all fluids in a suitable container for storage or disposal.
- Position Tooling (A) under the lift cylinder bracket, as shown.
Illustration 1 | g00535494 |
- Remove retainer (2) and pin (1) from the lift cylinder rod.
- Retract lift cylinder (3) and secure the cylinder rod, as shown.
Illustration 2 | g00535495 |
- Remove lamp assembly (4) and guard assembly (5) from the top of the lift cylinder.
Illustration 3 | g00556371 |
- Relieve all hydraulic pressure on the lift cylinders.
Illustration 4 | g00535499 |
- Remove hydraulic hose assemblies (6) for lift cylinder (3) .
- Fasten a hoist and Tooling (B) to lift cylinder (3), as shown.
- Disconnect wiring harness (7) from position sensor (8) .
Illustration 5 | g00535501 |
- Remove bolts (9) and bearing caps (10) from each side of the lift cylinder.
Illustration 6 | g00535503 |
- Remove lift cylinder (3) from the mounting yoke. The weight of the lift cylinder is approximately 250 kg (550 lb).