NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
- Operate the machine in order to warm the transmission oil.
- Park the machine on level ground. Lower the bucket to the ground and apply slight downward pressure. Engage the parking brake. Stop the engine.
Show/hide table
Illustration 1 g01095645 - Earlier machines will need to remove the transmission guard from the bottom of the machine in order to access the drain plug. Later machines have an access hole in the transmission guard for the transmission drain plug.
Note: The drain valve is an ecology drain valve.
- Remove the transmission drain plug from the bottom of the transfer gear case. Attach a hose to a 126-7914 Oil Drain Coupling. Install the threaded end of the coupling into the drain valve in order to unseat the internal drain valve. Allow the oil to drain into a suitable container.
Show/hide table
Illustration 2 g01095647 - The transmission oil filler tube is located near the articulation joint on the left side of the machine. Remove the transmission oil filler cap in order to ease drainage.
Show/hide table
Illustration 3 g01095648 - The transmission magnetic screen is located on the left side of the transfer gear case. The screen may be accessed through the left side of the rear frame, as shown.
Use the following procedure to clean the transmission magnetic screen:
- Remove bolts (1) and washers (2). Remove cover assembly (3) and seal (5).
- Remove screen tube assembly (6) and suction screen (7).
- Wash the screen tube assembly and the suction screen in a clean, nonflammable solvent.
- Install screen tube assembly (6) and suction screen (7).
- Inspect seal (5) for damage. Replace the seal, if necessary. Install seal (5) and cover assembly (3).
Show/hide tableNOTICE Do not drop or rap the magnets against any hard objects. Replace any damaged magnets.
Show/hide tableIllustration 4 g00838905 - Replace the transmission oil filter.
Reference: Refer to Operation and Maintenance Manual, "Transmission Oil Filter - Replace" for the correct procedure.
- Clean the transmission drain plug. Install the transmission drain plug.
- Fill the transmission with oil.
Reference: Refer to Operation and Maintenance Manual, "Capacities (Refill)" for the proper amount of oil.
- Clean the filler cap and install the filler cap.
Show/hide table
Illustration 5 g00935383 Transmission Breather - Open the access door in the platform behind the cab. Remove the transmission breather.
- Wash the breather in a clean, nonflammable solvent. Allow the breather to air dry or use air pressure to dry the breather. Install the breather.
- Start the engine and run the engine at low idle.
- Slowly operate the transmission control in order to circulate the oil. Return the transmission to neutral.
- Stop the engine. Inspect the entire transmission for leaks.
Show/hide table
Illustration 6 g00935572 - Check the transmission oil level.
Reference: Refer to Operation and Maintenance Manual, "Transmission Oil Level - Check" for the correct procedure.