Replacing Gaskets for the Engine Oil Cooler {1378}
- Engine: Commercial with Mechanical Unit Injection
- 3126
- Engine:
- 3116
- 3126
- 3126B
- Engine: Commercial with Mechanical Unit Injection
- 3116
- Generator Set:
- 3116
- 3126
Reference: Special Instruction, REHS2380, "Torque Procedure for the 0R-8839 Oil Cooler Core As "
Reference: Disassembly and Assembly, "Engine Oil Cooler - Remove"
Reference: Disassembly and Assembly, "Engine Oil Cooler - Install"
Gaskets for the 0R-8839 Oil Cooler Core As are available without ordering the 0R-8839 Oil Cooler Core As. The new gaskets are in the following table.
Show/hide table
Required Parts     | ||
Part Number     | Description     | Qty     |
233-7654     | Gasket     | 1     |
233-7655     | Gasket     | 1     |
Note: Do not use sealant when you are installing the gaskets.
Caterpillar Information System:
2004/11/01 Replacing Gaskets for the Engine Oil Cooler {1378}
2004/10/11 Replacing Gaskets for the Engine Oil Cooler {1378}
3406C Generator Sets Belts - Inspect/Adjust/Replace
On-Highway Engines Electronic PTO Installation and Application Guide 0231-12 J1939 Device Not Responding
G3516C and G3516E Gas Engines Fuel Lines
On-Highway Engines Electronic PTO Installation and Application Guide 0231-02 J1939 Data Incorrect (58)
On-Highway Engines Electronic PTO Installation and Application Guide 0030-08 PTO Throttle signal invalid (29)
On-Highway Engines Electronic PTO Installation and Application Guide 0030-13 PTO Throttle out of calibration (29)
On-Highway Engines Electronic PTO Installation and Application Guide 0071-14 PTO Shutdown (47)
On-Highway Engines Electronic PTO Installation and Application Guide Remote PTO Accelerator Position Sensor Circuit - Test
On-Highway Engines Electronic PTO Installation and Application Guide PTO Switch ON Lamp Circuit - Test
G3516C and G3516E Gas Engines Fuel Lines
G3512E Generator Set Engines Fuel Lines
Converting to Charge Density{1000} Converting to Charge Density{1000}
12M Motor Grader Stopping the Engine
330D, 336D and 340D Excavators Hydraulic System Pump Control (Main Hydraulic) - Main Pump Regulator
2004/10/01 New Ignition Transformers are Used {4476}
390D Excavator Fuel Tank Shutoff and Drain Control
2004/10/11 Remember to Calibrate the Engine Speed/Timing Sensor {1206, 1912}
2004/10/01 Remember to Calibrate the Engine Speed/Timing Sensor {1206, 1912}
2004/12/01 Improved Aftercooler Tubes {1380}
12M Motor Grader Towing the Machine
374F Excavator Ether Starting Aid Cylinder - Replace - If Equipped
374F Excavator Fuel Tank Water and Sediment - Drain