0071-14 PTO Shutdown (47)
Conditions Which Generate This Code:
The Engine Control Module (ECM) detects the following conditions:
- The timer for the PTO has expired and the engine has shut down.
- The PTO on/off switch is in the ON position.
- The "PTO Configuration" parameter is programmed to "Cab Switches", "Remote Switches", or "Remote Throttle".
- The "PTO Shutdown Time" parameter is programmed to at least three minutes.
System Response:
The ECM remains powered after the engine shutdown. "NOT ACTIVE" will be displayed next to the status for "PTO Shutdown" on Caterpillar Electronic Technician (ET).
Customer passwords are required to clear this diagnostic code.
The engine is shut down.
Test Step 1. Perform the following diagnostic procedure: PTO Shutdown Timer - Test
Results:
- OK - STOP
Caterpillar Information System:
On-Highway Engines Electronic PTO Installation and Application Guide Remote PTO Accelerator Position Sensor Circuit - Test
On-Highway Engines Electronic PTO Installation and Application Guide PTO Switch ON Lamp Circuit - Test
G3516C and G3516E Gas Engines Fuel Lines
On-Highway Engines Electronic PTO Installation and Application Guide PTO Switch Circuit - Test
On-Highway Engines Electronic PTO Installation and Application Guide PTO Shutdown Timer - Test
Installation Procedure for 257-4183 Injector Wiring Harness Kit {1408} Installation Procedure for 257-4183 Injector Wiring Harness Kit {1408}
G3516C and G3516E Gas Engines Crankcase Breather
C9 Industrial Engines Electronic Control System Components
C15 and C18 Industrial Engines Fuel Pressure Sensor - Remove and Install
C15 and C18 Industrial Engines Fuel Temperature Sensor - Remove and Install
C11 and C13 Engines Main Bearing Journal
C11 and C13 On-Highway Engines Connecting Rod Bearing Journal
On-Highway Engines Electronic PTO Installation and Application Guide 0030-13 PTO Throttle out of calibration (29)
On-Highway Engines Electronic PTO Installation and Application Guide 0030-08 PTO Throttle signal invalid (29)
On-Highway Engines Electronic PTO Installation and Application Guide 0231-02 J1939 Data Incorrect (58)
G3516C and G3516E Gas Engines Fuel Lines
On-Highway Engines Electronic PTO Installation and Application Guide 0231-12 J1939 Device Not Responding
3406C Generator Sets Belts - Inspect/Adjust/Replace
2004/10/11 Replacing Gaskets for the Engine Oil Cooler {1378}
2004/11/01 Replacing Gaskets for the Engine Oil Cooler {1378}
2004/11/01 Replacing Gaskets for the Engine Oil Cooler {1378}
G3512E Generator Set Engines Fuel Lines
Converting to Charge Density{1000} Converting to Charge Density{1000}
12M Motor Grader Stopping the Engine