Exhaust Manifold
Show/hide table
图 1 | g02153863 |
注: 涂抹密封胶前,排气歧管的阳性端和阴性端必须没有以下物质:污垢, 生锈, 润滑脂 和 机油。 在排气歧管的外径和内径上涂抹一薄层 3M 密封胶 EC - 1137。 去除组装好的接头上的多余的密封胶。
(1)舌片向下密封安装垫,如图所示 1。
(2) 拔梢锁紧双头螺柱的扭矩 ...
注: 在位置 11、7 和 9 使用组装隔套,以对准排气歧管。 在最后组装前拆除组装隔套。
注: 组装前,用 4C-5599 防粘结剂润滑锁止螺母的螺纹和轴承表面。
(3)将锁紧螺母 (1) 至 (12) 按照图 1 所示的数字顺序拧紧至扭矩为
Caterpillar Information System:
C27 and C32 Industrial and Petroleum Engines CID 0111 FMI 02 Engine Coolant Level Sensor Loss of Signal
C13, C15, and C18 Tier 4 Final Engines Exhaust Manifold
3406E and 3456 Generator Set Engines Electric Starting Motor
3406E and 3456 Generator Set Engines Electric Starting Motor
EMCP3 Generator Overfrequency Warning
C13, C15, and C18 Tier 4 Final Engines Vibration Damper
C15 and C18 Industrial Engines Vibration Damper
C15 and C18 Industrial Engines Vibration Damper
C-10, C-12, C-15 and C-16 Industrial Engines Throttle Position Sensor - Calibrate
C15 On-Highway Engine Variable Valve Actuators - Inspect/Adjust
C15 On-Highway Engines Vibration Damper - Check
C15 On-Highway Engines Slave Piston Lash - Adjust
EMCP3 Generator Overvoltage Warning
C15 and C18 Engines for Caterpillar Built Machines CID 2417 FMI 05 Ether Injection Control Solenoid current low
EMCP3 Generator Reverse Power Warning
C15 and C18 Engines for Caterpillar Built Machines CID 2417 FMI 06 Ether Injection Control Solenoid current high
3500 Engines for Caterpillar Built Generator Sets Engine Coolant Temperature Sensor
3500 Engines for Caterpillar Built Generator Sets Engine Oil Temperature Sensor
UPS Firmware Version 3.13 and 3.14 Update{7620} UPS Firmware Version 3.13 and 3.14 Update{7620}
EMCP3 Generator Underfrequency Warning
EMCP3 Generator Undervoltage Warning
EMCP3 Service Maintenance Interval Warning
EMCP3 Analog Input Circuit Fault
C9 On-Highway Engines Fuel System