Exhaust Manifold
Show/hide table
图 1 | g01446109 |
(1)组装前,将 4C-5599 防咬合剂涂抹到锁紧螺母的螺纹以及锁紧螺母和垫圈的支承面上。
(2)舌片向下安装密封垫,如图所示。
(3) 4 个锥形锁紧双头螺栓的扭矩 ...
(4) 12 个锥形锁紧双头螺栓的扭矩 ...
Caterpillar Information System:
3406E and 3456 Generator Set Engines Electric Starting Motor
3406E and 3456 Generator Set Engines Electric Starting Motor
EMCP3 Generator Overfrequency Warning
C13, C15, and C18 Tier 4 Final Engines Vibration Damper
C15 and C18 Industrial Engines Vibration Damper
C15 and C18 Industrial Engines Vibration Damper
C-10, C-12, C-15 and C-16 Industrial Engines Throttle Position Sensor - Calibrate
C15 On-Highway Engine Variable Valve Actuators - Inspect/Adjust
C15 On-Highway Engines Vibration Damper - Check
C15 On-Highway Engines Slave Piston Lash - Adjust
C15 On-highway Engine Jacket Water Heater
EMCP3 Generator Overcurrent Warning
C27 and C32 Industrial and Petroleum Engines CID 0111 FMI 02 Engine Coolant Level Sensor Loss of Signal
C13, C15, and C18 Tier 4 Final Engines Exhaust Manifold
EMCP3 Generator Overvoltage Warning
C15 and C18 Engines for Caterpillar Built Machines CID 2417 FMI 05 Ether Injection Control Solenoid current low
EMCP3 Generator Reverse Power Warning
C15 and C18 Engines for Caterpillar Built Machines CID 2417 FMI 06 Ether Injection Control Solenoid current high
3500 Engines for Caterpillar Built Generator Sets Engine Coolant Temperature Sensor
3500 Engines for Caterpillar Built Generator Sets Engine Oil Temperature Sensor
UPS Firmware Version 3.13 and 3.14 Update{7620} UPS Firmware Version 3.13 and 3.14 Update{7620}
EMCP3 Generator Underfrequency Warning
EMCP3 Generator Undervoltage Warning
EMCP3 Service Maintenance Interval Warning