CID 0111 FMI 02 Engine Coolant Level Sensor Loss of Signal
Conditions Which Generate This Code:
The signal from the coolant level sensor is missing.
System Response:
The Electronic Control Module (ECM) will log the diagnostic code. The diagnostic code may be viewed on a display module or on the electronic service tool.
Possible Performance Effect:
The loss of the signal does not affect engine performance. However, there will not be protection against low engine coolant level.
Troubleshooting:
Test Step 1. Perform the following diagnostic procedure: "Coolant Level Sensor Circuit - Test"
Results:
- OK - STOP
Caterpillar Information System:
C13, C15, and C18 Tier 4 Final Engines Exhaust Manifold
3406E and 3456 Generator Set Engines Electric Starting Motor
3406E and 3456 Generator Set Engines Electric Starting Motor
EMCP3 Generator Overfrequency Warning
C13, C15, and C18 Tier 4 Final Engines Vibration Damper
C15 and C18 Industrial Engines Vibration Damper
C15 and C18 Industrial Engines Vibration Damper
C-10, C-12, C-15 and C-16 Industrial Engines Throttle Position Sensor - Calibrate
C15 On-Highway Engine Variable Valve Actuators - Inspect/Adjust
C15 On-Highway Engines Vibration Damper - Check
C15 On-Highway Engines Slave Piston Lash - Adjust
C15 On-highway Engine Jacket Water Heater
C13, C15, and C18 Tier 4 Final Engines Exhaust Manifold
EMCP3 Generator Overvoltage Warning
C15 and C18 Engines for Caterpillar Built Machines CID 2417 FMI 05 Ether Injection Control Solenoid current low
EMCP3 Generator Reverse Power Warning
C15 and C18 Engines for Caterpillar Built Machines CID 2417 FMI 06 Ether Injection Control Solenoid current high
3500 Engines for Caterpillar Built Generator Sets Engine Coolant Temperature Sensor
3500 Engines for Caterpillar Built Generator Sets Engine Oil Temperature Sensor
UPS Firmware Version 3.13 and 3.14 Update{7620} UPS Firmware Version 3.13 and 3.14 Update{7620}
EMCP3 Generator Underfrequency Warning
EMCP3 Generator Undervoltage Warning
EMCP3 Service Maintenance Interval Warning
EMCP3 Analog Input Circuit Fault