Installation Procedure
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 1P-0074 | Puller Assembly | 1 |
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines. Dispose of all fluids according to local regulations and mandates. |
 |
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
 |
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install bearing (1) in the flywheel.
 | |
| Illustration 1 | g00330187 |
- Install ring (2) that holds the bearing in place.
- Install springs (3) in the flywheel.
- Install gear (4) .
 | |
| Illustration 2 | g00330190 |
- Install ring (5) that holds the gear in position.
- Fasten the hoist to torque divider (6). Make sure that the wire will keep the carrier on the shaft as the torque divider is installed.
 | |
| Illustration 3 | g00348707 |
- Position torque divider (6). Turn the gear in the torque divider and turn the gear in the flywheel until the gears engage.
 | |
| Illustration 4 | g00348732 |
- Install the washers and twelve nuts (7) .
Note: Do not push the flywheel on all the way. Remove the wire from the forcing screws and the carrier.
- Connect oil line (8) .
- Install the transmission line for the vent.
End By:
- Install the torque converter outlet relief valve. Refer to Disassembly and Assembly, "Relief Valve (Torque Converter Outlet) - Install".
- Install the sequence relief valve. Refer to Disassembly and Assembly, "Relief Valve (Sequence) - Install".
- Install the lubrication relief valve. Refer to Disassembly and Assembly, "Lubrication Relief Valve - Remove and Install".
- Install the universal joint. Refer to Disassembly and Assembly, "Universal Joint - Remove and Install".
- Install the hydraulic tank. Refer to Disassembly and Assembly, "Hydraulic Tank - Remove and Install".
- Install the dash panel. Refer to Disassembly and Assembly, "Dash Panel - Remove and Install".
- Install the support and the seat group. Refer to Disassembly and Assembly, "Seat Support - Remove and Install".
- Install the crankcase guard. Refer to Disassembly and Assembly, "Crankcase Guard - Remove and Install".
- If the machine has a cab tilt the cab forward. If the machine does not have a cab, install the rollover protective structure.