Engine to Torque Converter - Connect
Connection Procedure
- Thoroughly clean the mating surfaces of the torque converter and the engine prior to the connection.
- Replace the O-ring seals that are used in the installation of the torque converter. Use new parts for the replacement.
- Install O-ring seal (12) in the groove of the flange face of the torque converter, as shown.
Show/hide table
Illustration 1 | g00300747 |
- Install large O-ring seal (11) on the torque converter case.
- Lubricate the O-ring seals slightly with clean transmission oil.
- Use a hoist, suitable lifting chains and Tooling (B) to align torque converter (9) to the engine for the connection.
Show/hide table
Illustration 2 | g00300746 |
- Fasten the torque converter to the engine with sixteen bolts (8). The torque for the bolts is 215 ± 40 N·m (160 ± 30 lb ft).
Show/hide table
Illustration 3 | g00301178 |
- Connect hose assembly (5) to the torque converter.
- Install bracket (6) that holds hose assembly (7) to the bottom of the torque converter.
- Install fan speed solenoid (3) and two bolts (4) .
Show/hide table
Illustration 4 | g00300741 |
- Connect electrical harness connector (1). Install two harness clips (2) .
End By: Install the engine and the torque converter assembly. Refer to Disassembly and Assembly, "Engine and Torque Converter - Install".
Caterpillar Information System:
631E Series II, 633E Series II and 637E Series II Wheel Tractor-Scrapers Air System and Brakes Check Valve (Air Tank)
854G Wheel Tractor and 992G Wheel Loader Engine Supplement Engine from Torque Converter - Separate
914G Wheel Loader Single Lever Control
627F Wheel Tractor-Scraper Wheel Scraper Power Train Pressure Control Valve
IT14G Integrated Toolcarrier Ride Control - If Equipped
IT14G Integrated Toolcarrier Steering Column Tilt Control
IT14G Integrated Toolcarrier Steering Control
621F and 627F Wheel Tractor-Scrapers Hydraulic System Cutting Edges and End Bits
IT14G Integrated Toolcarrier Speed Control - If Equipped
IT14G Integrated Toolcarrier Direction Control
IT14G Integrated Toolcarrier Service Brake Control
914G Wheel Loader Parking Brake Control
914G Wheel Loader Multipurpose Control
IT14G Integrated Toolcarrier Hydraulic Lockout Control
3406E and 3456 Engines for Caterpillar Built Machines Compression Brake
IT14G Integrated Toolcarrier Bucket Kickout and Positioner Control
IT14G Integrated Toolcarrier Walk-Around Inspection
IT14G Integrated Toolcarrier Starting Above 0°C (32°F)
621F and 627F Wheel Tractor-Scrapers Hydraulic System Bowl Cylinder
Caterpillar Monitoring System Tattletale Mode
994D Wheel Loader Steering System Steering Control Valve
621F and 627F Wheel Tractor-Scrapers Hydraulic System Apron Cylinder
637E Wheel Tractor-Scraper Wheel Scraper Power Train Relief Valve (Transmission Lubrication) - Scraper
3054 Engine Rocker Shaft