Drive Shaft Spline (Center) - Lubricate
Wipe all of the fittings before you apply grease to the fittings.
Show/hide table
NOTICE |
---|
To prevent damage to the seal, articulate the machine full right or left, before lubricating the splines. |
- Start the engine. Raise the bucket. Release the parking brake. Articulate the machine to the right or to the left in order to gain better access to the splined shaft.
- Lower the bucket to the ground. Engage the parking brake. Stop the engine.
Show/hide table
Illustration 1 g00882399 Location of the center drive shaft Show/hide tableIllustration 2 g00882402 - Apply grease to the fitting (1). Apply grease until the relief (2) overruns.
Note: 5P-0960 Molybdenum Grease is preferred. 1P-0808 Multipurpose Grease may be used.
- Start the engine. Raise the bucket. Release the parking brake. Reposition the machine in a straight direction without articulation.
- Lower the bucket to the ground. Apply a slight down pressure. Engage the parking brake. Stop the engine.
Caterpillar Information System:
966G and 972G Wheel Loaders Drive Shaft Universal Joints - Lubricate
950G Wheel Loader, 962G Wheel Loader and IT62G Integrated Toolcarrier Power Train Transmission Planetary
966G and 972G Wheel Loaders Cooling System Water Temperature Regulator - Replace
3412 Generator Set Engines Electric Starting Motor
938G Wheel Loader and IT38G Integrated Toolcarrier Machine Systems Brake Valve (Proportional) (Traction Control System) - Install
3508B Engine for Caterpillar Built Machines Dust Ejector
966G and 972G Wheel Loaders Cooling System Level - Check
627F Wheel Tractor-Scraper Push-Pull Hydraulic System General Information
621F, 623F and 627F Wheel Tractor-Scrapers Power Train Transmission Planetary
938G Wheel Loader and IT38G Integrated Toolcarrier Machine Systems Brake Valve (Proportional) (Traction Control System) - Remove
938G Wheel Loader and IT38G Integrated Toolcarrier Steering System Pressure and Flow Compensator Valve (Steering)
3508B Engine for Caterpillar Built Machines Radiator - AMOCS
994 Wheel Loader Steering System Steering Oil Temperature Switch
994D Wheel Loader Steering System Pressure Switch (Steering)
938G Wheel Loader and IT38G Integrated Toolcarrier Hydraulic System Pilot System Pressure - Test
994 Wheel Loader Steering System Steering Pilot Check Valve
938G Wheel Loader and IT38G Integrated Toolcarrier Machine Systems Hydraulic Tank - Remove
994D Wheel Loader Steering System Check Valve (Steering)
938G Wheel Loader and IT38G Integrated Toolcarrier Machine Systems Hydraulic Tank - Install
994D Wheel Loader Steering System Check Valve (Steering and Brake Oil Cooler Bypass)
631E Series II, 633E Series II and 637E Series II Wheel Tractor-Scrapers Cushion-Hitch Hydraulic System Pressure Compensator Valve (Piston Pump)
3508B Engine for Caterpillar Built Machines Alternator Mounting
938G Wheel Loader and IT38G Integrated Toolcarrier Braking System Parking Brake Alarm Relay
938G Wheel Loader and IT38G Integrated Toolcarrier Hydraulic System Main Control Valve