Diagnostic Codes
Show/hide table
| 闪烁代码 | 代码 | 代码描述 |
|---|---|---|
| 84-14 | 急停事件 | |
| 171-03 | 环境空气温度电压过高 | |
| 171-04 | 环境空气温度电压过低 | |
| 171-11 | 环境空气温度数据丢失 | |
| 01 | 71-00 | 怠速停机超越 |
| 02 | 244-02 | 事件记录器数据丢失 |
| 12 | 111-02 | 冷却液液位信号无效 |
| 13 | 174-03 | 燃油温度电压过高 |
| 174-04 | 燃油温度电压过低 | |
| 14 | 121-05 | 低/高减速器电流过低 |
| 121-06 | 低/高减速器电流过高 | |
| 122-05 | 中/高减速器电流过低 | |
| 122-06 | 中/高减速器电流过高 | |
| 21 | 41-03 | 8 伏电源电压过高 |
| 41-04 | 8 伏电源电压过低 | |
| 232-03 | 8 伏电源电压过高 | |
| 232-04 | 8 伏电源电压过高 | |
| 24 | 100-03 | 机油压力电压过高 |
| 100-04 | 机油压力电压过低 | |
| 25 | 102-00 | 增压压力过高 |
| 102-03 | 增压压力电压过高 | |
| 102-04 | 增压压力电压过低 | |
| 26 | 108-03 | 大气压力电压过高 |
| 108-04 | 大气压力电压过低 | |
| 27 | 110-03 | 冷却液温度电压过高 |
| 110-04 | 冷却液温度电压过低 | |
| 28 | 91-13 | 油门位置超出标定范围 |
| 29 | 30-08 | PTO 油门信号无效 |
| 30-13 | PTO 油门超出标定范围 | |
| 31 | 84-01 | 车速信号丢失 |
| 32 | 91-08 | 油门位置无效 |
| 34 | 190-02 | 主发动机转速信号丢失 |
| 35 | 190-00 | 发动机超速警告 |
| 36 | 84-02 | 车速信号无效 |
| 84-08 | 车速信号超出正常范围 | |
| 84-10 | 车速信号变化率 | |
| 38 | 105-03 | 进气歧管温度电压过高 |
| 105-04 | 进气歧管温度电压过低 | |
| 41 | 84-00 | 车辆超速警告 |
| 42 | 22-13 | 未进行发动机转速信号标定 |
| 102-13 | 增压压力超出标定范围 | |
| 46 | 100-01 | 机油压力低警告 |
| 100-11 | 机油压力极低 | |
| 47 | 71-01 | 怠速停机 |
| 71-14 | PTO 停机 | |
| 51 | 168-02 | ECM 蓄电池电源不连续 |
| 53 | 254-12 | ECM 故障 |
| 55 | N/A | 没有检测到故障诊断代码 |
| 56 | 253-02 | 检查用户或系统参数 |
| 253-11 | 检查变速箱用户参数 | |
| 58 | 231-11 | J1939 数据链路故障 |
| 249-11 | J1922 数据链路故障 | |
| 59 | 252-11 | 发动机软件不正确 |
| 61 | 110-00 | 冷却液温度过高警告 |
| 110-11 | 冷却液温度极高 | |
| 62 | 111-01 | 冷却液液位过低警告 |
| 111-11 | 冷却液液位极低 | |
| 64 | 105-00 | 进气歧管温度过高警告 |
| 105-11 | 进气歧管温度极高 | |
| 65 | 174-00 | 燃油温度过高警告 |
| 66 | 40-05 | 02 号辅助输出电流过低 |
| 40-06 | 02 号辅助输出电流过高 | |
| 67 | 51-05 | 03 号辅助输出电流过低 |
| 51-06 | 03 号辅助输出电流过高 | |
| 68 | 191-07 | 变速箱没有响应 |
| 69 | 26-05 | 01 号辅助输出电流过低 |
| 26-06 | 01 号辅助输出电流过高 | |
| 71 | 43-02 | 钥匙开关故障 |
| 72 | 1-11 | 1 号气缸喷油器电流故障 |
| 2-11 | 2 号气缸喷油器电流故障 | |
| 73 | 3-11 | 3 号气缸喷油器电流故障 |
| 4-11 | 4 号气缸喷油器电流故障 | |
| 74 | 5-11 | 5 号气缸喷油器电流故障 |
| 6-11 | 6 号气缸喷油器电流故障 |
Caterpillar Information System:
C15 and C18 Engines for Caterpillar Built Machines Fan Drive
3500B Marine Propulsion Engines Battery - Replace
C15 and C18 Generator Set Engines Electronic Unit Injector - Remove
2006/01/02 Relocation of the Fuel Transfer Pump is Recommended for Certain Applications. {1256}
2004/04/01 Relocation of the Fuel Transfer Pump is Recommended for Certain Applications. {1256}
3406E, C-10, C-12, C-15, C-16 Truck Engines Product Storage
3406E, C-10 and C-12 On-highway Engines Poor Acceleration or Response
Product Link - PL102C System Overview
3406E, C-10 and C-12 On-highway Engines Low Power/Poor or No Response to Throttle
C15 and C18 Industrial Engines Belt Tightener
3406E, C-10 and C-12 On-highway Engines Intermittent Low Power or Power Cutout
C-15 Petroleum Engine Engine Oil Pan
C15 and C18 Engines for Caterpillar Built Machines Flywheel Housing
2004/05/01 New Water Lines Groups are Used for Venting of the Separate Circuit Aftercooler {1380}
G3300 Engines Cooling System Coolant (NGEC) - Change
C-12 Generator Set Engine CID 0268 FMI 02 Check Programmable Parameters
SCJ and 8SC Series Alternators Service Tools
SCJ and 8SC Series Alternators Charging System
C-10 and C-15 Petroleum Engines Engine Speed/Timing Sensor Circuit - Test
C18 Generator set and C18 Marine Engines Heat Exchanger - Disassemble - With Fuel Cooler
C18 Generator set and C18 Marine Engines Heat Exchanger - Assemble - Without Fuel Cooler
2004/06/01 Realignment of Air System Components is Recommended. {1063}
C15 Petroleum Engine After Stopping Engine
C-10 and C-15 Petroleum Engines Ether Injection System - Test