Cylinder Liner
Show/hide table
Illustration 1 | g01026513 |
(1) Bore
-
3408B, 3408C, 3412, and 3412C engines
- Bore in new cylinder liner ... 137.185 ± 0.025 mm (5.4010 ± 0.0010 inch)
-
3412D engines
- Bore in new cylinder liner ... 145.000 ± 0.025 mm (5.7087 ± 0.0010 inch)
(2) Flange
-
Flange on cylinder liner
- Thickness ... 8.89 ± 0.02 mm (0.350 ± 0.001 inch)
- Minimum thickness ... 8.87 mm (0.349 inch)
(3) Filler band
Use the following procedure to install the cylinder liner:
- Put liquid soap on the cylinder block liner bore surfaces and the rubber seals that are on the lower end of the cylinder liner.
- Dip the filler band completely in clean engine oil.
- Immediately install the filler band in the groove that is under the cylinder liner flange.
- Install the cylinder liner into the cylinder block before the expansion of the filler band.
Note: Refer to Guideline For Reusable Parts, SEBF8049, "Pistons" for more information. Also, refer to Guideline For Reusable Parts, SEBF8068, "Cylinder Liners" for more information.
Caterpillar Information System:
2003/08/01 Use the Correct Front Housing Bolts {1151}
Cat® Digital Voltage Regulator Poor Voltage Regulation - Troubleshoot
Cat® Digital Voltage Regulator No Line Loss Compensation - Troubleshoot
C15 On-Highway Engine Flywheel Housing
Cat® Digital Voltage Regulator No Voltage Droop - Troubleshoot
Cat® Digital Voltage Regulator Unstable Voltage - Troubleshoot
C15 Petroleum Generator Set Engines Housing (Front)
C11 and C13 Engines for Caterpillar Built Machines Camshaft Bearings - Remove
C15 Engine Engine Protection Plans
C11 and C13 Engines for Caterpillar Built Machines Inlet and Exhaust Valve Springs - Remove and Install
C13 and C15 On-Highway Engines Cooling System Supplemental Coolant Additive (SCA) - Test/Add
C11 and C13 Engines Cylinder Head - Install
C11 and C13 Engines for Caterpillar Built Machines Camshaft Bearings - Install
345B Excavator Swing Drive Oil Sample - Obtain
3500B Series II Marine Engines Digital Sensor Supply
G3520C and G3520E Generator Set Engines Actuator Bypass Valve (Variable) - Install
2003/08/01 New Oil Pump with a Longer Service Life {1304}
G3406 Engines Gas Solenoid Valve
C13 Engine Connecting Rod Bearings - Remove
C13 Engine Connecting Rod Bearings - Install
G3406 Engines Coolant Temperature Contactor
G3406 Engines Engine Oil Pressure Switch
3412 Generator Set Engines Engine Oil Pressure Sensor
G3406 Engines Engine Oil Pressure Sensor