Usage:
(1) Put clean engine oil on seal surface of collar before assembly.
(2) Rubber torics and all surfaces contacting them must be clean and dry at assembly. Apply a thin film of oil to contacting surfaces of the metal seal rings just prior to assembly. Seal rings must be assembled square with the bore and the torics and must not be bulged or twisted. Put lubricant on all other seals at assembly.
(3) At assembly, put the machined face of plate against end of shaft.
(4) Put .25 liter (1/2 pint) of SAE 30W oil in roller.
(5) At installation, put liquid soap on seal.
D5C
(1) Assemble shaft even with the back of the bracket. Make an adjustment if necessary for track alignment.
(2) Rubber torics and all surfaces contacting them must be clean and dry at assembly. Apply a thin film of oil to contacting surfaces of the metal seal rings just prior to assembly. Seal rings must be assembled square with the bore and the torics and must not be bulged or twisted. Put lubricant on all other seals at assembly.
(3) At assembly, put the machined face of plate against end of shaft.
(4) Torque for bolts ... 47 ± 9 N·m (35 ± 7 lb ft)
(5) Put lubricant on seal surface of collar before assembly.
(6) Torque for plug ... 170 ± 20 N·m (125 ± 15 lb ft)