D3C, D4C AND D5C SERIES II TRACTORS POWER TRAIN Caterpillar

NOTE: When tooling (A) is used the rear guard can only be removed by the way of the front of the machine. The frame is too low at the rear of the machine. This will make it necessary to raise and lock the bucket on the 939 or raise and block on the D4C.

D4C

939

1. Using tooling (A) (not shown) support rear guard assembly (2) and remove eight bolts and washers (1). Lower rear guard assembly (2) to the ground and slide out the front of the machine. Weight of the guard is 39 kg (86 lb).

Access cover for transmission drain

Access cover for drive shaft tube

NOTE: Install in the reverse order.