Usage:
Typical Example
NOTE: Apply 9S3263 Thread Lock to all plugs in the steering clutch case that do not have O-ring seals.
(1) Apply 9S3263 Thread Lock then tighten 12.7 mm (1/2 in) studs (12 each side) to a torque of ... 55 ± 7 N·m (41 ± 5 lb ft)
(2) Apply 9S3263 Thread Lock then tighten 9.5 mm (3/8 in) studs (12 each side) to a torque of ... 30 ± 4 N·m (22 ± 3 lb ft)
(3) Apply 9S3263 Thread Lock to two plugs in case. Tighten to a torque of ... 45 ± 7 N·m (33 ± 5 lb ft)
(4) Apply 3S6252 Sealant to mating surfaces of covers and case as required (5 places). Clean all oil, dirt and paint from case and covers before applying sealant.
(5) Apply 9S3263 Thread Lock to threads of bolts that hold five covers to case.
(6) Distance from end of dowel (two each side) to case ... 15.8 ± 0.8 mm (.62 ± .03 in)
(7) Apply 5P3413 Thread Sealant to threads of bolts that hold the frame assembly to the case then tighten to a torque of ... 370 ± 50 N·m (270 ± 37 lb ft)
(8) Torque for eight bolts. Tighten at head end ... 370 ± 50 N·m (270 ± 37 lb ft)
NOTICE |
---|
All plates, brackets and clips that are attached to the clutch case, must be installed prior to final torque of cover assemblies A, B, and C. This is to ensure that cover to case joints and threaded joints are properly sealed. |
NOTICE |
---|
After assembly of final drives, bevel gear, steering clutches, and brakes to case, pressurize clutch compartments with 35 kPa (5 psi) air to assure sealing. |
D4C and D5C
Typical Example
NOTE: Apply 9S3263 Thread Lock to all plugs in the steering clutch case that do not have O-ring seals.
(1) Distance from end of dowel (two each side) to case ... 15.8 ± 0.8 mm (.62 ± .03 in)
(2) Apply 3S6252 Sealant to mating surfaces of covers and case as required (5 places). Clean all oil, dirt and paint from case and covers before applying sealant.
(3) Apply 9S3263 Thread Lock to threads of bolts that hold five covers to case.
(4) Apply 9S3263 Thread Lock to two plugs in case. Tighten to a torque of ... 45 ± 7 N·m (33 ± 5 lb ft)
(5) Apply 5P3413 Thread Sealant to threads of bolts that hold the frame assembly to the case. Tighten 14 bolts to a torque of ... 370 ± 50 N·m (270 ± 37 lb ft)
(6) Torque for eight bolts (tighten at head end) ... 370 ± 50 N·m (270 ± 37 lb ft)
NOTICE |
---|
All plates, brackets and clips that are attached to the clutch case, must be installed prior to final torque of cover assemblies A, B, and C. This is to ensure that cover to case joints and threaded joints are properly sealed. |
NOTICE |
---|
After assembly of final drives, bevel gear, steering clutches, and brakes to case, pressurize clutch compartments with 35 kPa (5 psi) air to assure sealing. |