Fuel Filter Base
Show/hide table
图 1 | g00996642 |
(1) 双头螺栓
-
将 154-9731 螺纹锁固胶 涂覆到双头螺栓锥形端最后的 7.6 mm (.30 in) 长的部位上。
- 扭矩 ... 70 ± 15 N·m (50 ± 11 lb ft)
(2) 从燃油滤清器底座密封表面到双头螺栓端部的距离 ... 24.6 ± 1.3 mm (0.97 ± 0.05 in)
Caterpillar Information System:
Product Link 151/201 Installation Examples
C27 and C32 Industrial and Petroleum Engines CID 0102 FMI 10 Boost Pressure Sensor abnormal rate of change
C27 and C32 Generator Set Engines CID 0100 FMI 10 Engine Oil Pressure Sensor abnormal rate of change
C1.5 and C2.2 Generator Exciter Field - Flash
G3500 Engines Prelube Pump - Air
C1.5 and C2.2 Marine Generator Set Engines Water Temperature Regulator - Remove and Install
G3520C and G3520E Generator Set Engines Cylinder Head - Assemble
G3520C and G3520E Generator Set Engines Cylinder Head - Disassemble
C1.5 and C2.2 Marine Generator Set Engines Expansion Tank - Remove and Install
3500 Engines for Caterpillar Built Generator Sets Engine Oil Filter Base
C1.5 and C2.2 Marine Generator Set Engines Water Temperature Regulator Housing - Remove and Install
3054C Industrial Engine Fuel Injection Pump - Install - Bosch EVPE
Product Link 151/201 Spare Input Installation
Product Link 151/201 System Installation
Product Link 151/201 Setup
Product Link 151/201 Configuration
Product Link 151/201 Installation Parameters Configure
Product Link 151/201 Report Parameters Configure
Product Link 151/201 Wireless Service Configure
Product Link 151/201 Spare Input Configure
G3500 Engines Air Starting System - Starting with an Air Prelube Pump
Product Link 151/201 Commands
3618 Engine Starting Motor - Inspect
G3500B Engines Electrohydraulic System Components