Lubricant Gives Protection To Camshaft And Roller During Initial Start-Up{1210,1209}
Usage:
3200 Series Engines
Caterpillar service literature makes the recommendation that engine oil be put on the camshaft and the valve lifter roller when they are assembled. This gives protection for initial (first) start-up after an overhaul. For extra protection a 2P2506 Lubricant can be used on the camshaft lobes and lifter rollers. This lubricant gives good protection in high pressure - low temperature applications. Also, the 2P2506 Lubricant will not cause any wrong indications in oil sample tests.
NOTE: The 2P2506 Lubricant must not be put on camshaft journals or bearings. Because of its high viscosity, it can cause foreign material to be held in the journal area. This can cause a decrease in bearing service life.
Caterpillar Information System:
1981/09/21 Use Only EPA-Approved Rack And Idle Setting; Change Seal, Date Plate{1257,1251,1264}
1981/09/21 New Dual Speed Switch Is Now Available{7418,7410,7411,1400}
1981/09/21 Preventive Maintenance For Natural Gas Engine Spark Ignition System{1550,1552,1555,1558}
1981/09/14 Spring Pins No Longer Used In Water Pump Drive Gear {1361}
1981/09/14 Low Idle Instability: New Low Idle Setting {1264}
1981/09/14 Timing Pin Removed From Governor And Fuel Injection Pump Group; Change To Service Manuals {1286}
1981/09/14 Exhaust Manifold And Air Lines Changes Prevent Broken Studs And Exhaust Leaks {1059,1061}
1981/09/14 Troubleshooting: Water Pump Failures {1361,1350}
1981/09/14 Changes To BrakeSaver Groups Give Longer Service Life {1155}
1981/09/14 Updated, Improved Issue of Special Instruction, "Bench Testing Hydraulic Components," Now Available {0374,5050}
1981/09/14 New High Pressure Quick Disconnect Couplers And Nipples For Hydraulic Test Equipment {0651}
1981/09/07 New Support Prevents Vibration Of Left Side Oil Filters{1306,1318}
1981/09/28 Oil Pan Drain Plug Has More Threads{1302}
1981/09/28 Wrong Assembly Or Adjustment Of Governor Linkage Can Cause Failure{1289,1264,1265}
1981/10/05 Service Manual Information About Inside Diameters Of Valve Guides{1104,0374}
1981/10/05 Hydraulic Cylinder Repair Stands And Kits Now Available From Caterpillar Parts Department{0623,0626}
1981/10/05 New Torque Specifications For Flared And O-Ring Fittings{5057,7553}
1981/10/05 New Piston Ring Group For Parts Service In Natural Gas Applications{1215}
1981/10/05 Bolt Torque Specifications Changed For Crankshaft Pulley And Power Take-Off Adapter{1205,1165}
1981/10/12 New Cylinder Block Permits Use Of A Small-Frame Turbocharger{1201,1052}
1981/10/12 Use Of Engine Supports On Flywheel Housing Can Change Face And Bore Runout Measurements{1157}
1981/10/12 Engine Slobbering; New Piston And Rings Used{1214,1215,1000,1225,1104,1052}
1981/10/12 FT1561 Cylinder Liner Storage Cabinet{0632}
1981/10/19 FT1565 Valve Guide Removal And Installation Tool{0623,0624,1104}