Starting the Engine
Show/hide table
不要使用类似乙醚的喷雾式起动辅助装置。 否则可能导致爆炸和人身伤害。 |
Show/hide table
注意 |
---|
发动机盘车时间不要超过 10 秒钟。 再次盘车前,让起动马达冷却30秒钟。 当飞轮正在转动时,不要接合起动马达。 |
- 从发动机上卸下负载。 脱开任何被驱动设备。
- 根据表1开启电热塞。
Show/hide table
表 1 预热时间     温度     预热时间    
5 °C (41 °F)    10 秒    
−5 °C (23 °F)至
4 °C (40 °F)    20 秒     低于
−5 °C (23 °F)    30 秒     持续预热     最长60秒    
- 盘动发动机。 起动发动机。
- 对发动机加载前,让发动机怠速运转5-10分钟。 检查机油压力表。 机油压力表应显示合适的数值。
Caterpillar Information System:
G3500B Engines Prelube Pump - Air
3044C Industrial Engine and Engines for Caterpillar Built Machines Crankshaft
G3500 Engines Prelube Pump - Air
3046 Engine for Caterpillar Built Machines Connecting Rod - Inspect
3044C Industrial Engine and Engines for Caterpillar Built Machines Cylinder Head - Inspect
R1600H Load Haul Dump Turbocharger - Inspect
3044C Industrial Engine and Engines for Caterpillar Built Machines Gear Group - Inspect
G3500B Engines Air Starting Motor - Turbine
3046 Engine for Caterpillar Built Machines Flywheel - Inspect
C11, C13, and C15 On-highway Engines Compression Brake - If Equipped
G3520C and G3520E Generator Set Engines Rocker Shaft - Assemble
G3520C and G3520E Generator Set Engines Rocker Shaft - Disassemble
G3500B Engines Prelube Pump - Electric
G3516B Engines Replacing the ITSM
3034 Engine for Caterpillar Built Machines Crankshaft - Remove
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply EMI Filter Board - Remove and Install
Cat Gas Engine Lubricant, Fuel, and Coolant Recommendations Aftermarket Oil Additives
G3500 Engines Prelube Pump
Cat Gas Engine Lubricant, Fuel, and Coolant Recommendations Dry Natural Gas - Pipeline
G3500 A3 Engines Prelube Pump - Electric
C11, C13 and C15 On-highway Engines ATA (SAE J1587 / J1708) Data Link Circuit - Test
G3500B Engines Exhaust Manifold
3044C Industrial Engine Turbocharger - Inspect - If Equipped
3044C Industrial Engine and Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust