Usage:
The fiber/rubber strips which are part of the plate assemblies used in the radiator baffle group are not serviceable. During certified rebuilds, the strips on the plate assemblies should be replaced if worn or damaged.
The fiber/rubber strips can be fabricated from 5.00 mm (.197 in) thick milled fiber reinforced rubber belting material. To fabricate the strips, see the illustrations below for the locations, and chart for the required dimensions. After fabrication, use 6B4594 Rivets to fasten the new strips to the plate assemblies.
Do not perform any procedure, outlined in this publication, or order any parts until you read and understand the information contained within.
Do not attempt to assemble this attachment until you have read and understand the assembly instructions. Improper procedures could result in injury. |
Illustration 1.
View of air baffle group. Locations of rubber strips which must be fabricated. See the appropriate illustration and the chart for the dimensions and quantity required to fabricate each strip.
Illustration 2. One strip required.
Dimensions required to fabricate strip (1). (H) = Four holes.
Illustration 3. One strip required.
Dimensions required to fabricate strip (2). (H) = Nine holes.
Illustration 4. Two strips required.
Dimensions required to fabricate strip (3). (H) = Nine holes. Saw cut three places as shown.
Illustration 5. One strip required.
Dimensions required to fabricate strip (5). (H) = Two holes.
Illustration 6. One strip required.
Dimensions required to fabricate strip (6). (H) = 11 Holes.
Illustration 7. One strip required.
Dimensions required to fabricate strip (7). (H) = Six holes.
Illustration 8. One strip required.
Dimensions required to fabricate strip (8). (H) = Five holes.
Illustration 9. One strip required
Dimensions required to fabricate strip (9). (H) = Three holes.
Illustration 10. Six strips required
Dimensions required to fabricate strip (10). (H) = Three holes.
Illustration 11. One strip required
Dimensions required to fabricate strip (11). (H) = Two holes.
Illustration 12. One strip required.
Dimensions required to fabricate strip (12). (H) = Seven holes. H2 = One hole. Cut (XY) to (XZ).
Illustration 13. One strip required
Dimensions required to fabricate strip (13). (H) = Three holes.
Illustration 14. One strip required
Dimensions required to fabricate strip (4). (H) = Four holes.