Stopping the Engine
注: 不同应用采用不同的控制系统。 运用以下一般性准则以便使发动机停机。
- 从发动机上卸下负载。
- 按下 STOP（停机）拨动开关，以便使发动机停机。
Caterpillar Information System:
C1.5 and C2.2 Generator Sets Engine Warm-up
G3500 A3 Engines ECM Output Circuit (Prelubrication Oil Pump)
G3500 A3 Engines Engine Pre-Lube Pressure (Low)
C1.5 and C2.2 Engines for Caterpillar Built Marine Generator Sets Exhaust Manifold
C9 Marine Engines System Configuration Parameters
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Air Inlet and Exhaust System - Inspect
3056E Industrial Engine Belt Tension Chart
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Charging System - Test
2003/02/03 Checking the Motor Rotation after Replacing the Blower Motor Can Increase Service Life {7304, 7320}
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Cylinder Head - Inspect
C13 Engines for Caterpillar Built Machines Compression Brake
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Cooling System - Check - Overheating
3054E Industrial Engine Inlet and Exhaust Valve Springs - Remove and Install
3054E Industrial Engine Inlet and Exhaust Valves - Remove and Install
C13 Engine for Combat and Tactical Vehicles Cooling System
3054E Industrial Engine Inlet and Exhaust Valve Guides - Remove and Install
3044C Industrial Engine Fuel and the Effect from Cold Weather
3054E Industrial Engine Water Temperature Regulator - Remove and Install
G3600 Engines Gas Engine Ignition - Bio-Gas Fuel
C1.5 and C2.2 Generator Sets Auxiliary Water Pump (Rubber Impeller) - Inspect
G3606 and G3608 Engines Gas Engine Ignition - Bio-Gas Fuel
322B L and 325B L Excavators, 322B and 325B Forest Machines and 325B Material Handler Swing Drive Oil Sample - Obtain
G3520B Engines MID 033 - CID 0168 - FMI 02 System Voltage intermittent/erratic
C9 Marine Engines Engine Cranks but Will Not Start