Belt Tension Chart
Show/hide table
Belt Tension Chart | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
Size of Belt | Width of Belt | Gauge Reading | Borroughs Gauge Numbers | |||||||
Initial Belt Tension(1) | Used Belt Tension(2) | Number of the Selected Gauge | ||||||||
1/2 | |
|
|
BT-33-97 | ||||||
Measure the tension of the belt that is farthest from the engine. |
Show/hide table
(1) | Initial Belt Tension refers to a new belt. |
(2) | Used Belt Tension refers to a belt that has been in operation for 30 minutes or more at the rated speed. |
Caterpillar Information System:
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Charging System - Test
2003/02/03 Checking the Motor Rotation after Replacing the Blower Motor Can Increase Service Life {7304, 7320}
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Cylinder Head - Inspect
C13 Engines for Caterpillar Built Machines Compression Brake
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Cooling System - Check - Overheating
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Increased Engine Oil Temperature - Inspect
C18 Generator set and C18 Marine Engines Auxiliary Water Pump - Assemble - Type 1
C18 Generator set and C18 Marine Engines Auxiliary Water Pump - Disassemble - Type 1
C11, C13 and C15 On-highway Engines System Overview
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Vehicle Speed and Speedometer Circuit - Test
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Two Speed Axle Switch Circuit - Test
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Tachometer Circuit - Test
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Air Inlet and Exhaust System - Inspect
C9 Marine Engines System Configuration Parameters
C1.5 and C2.2 Engines for Caterpillar Built Marine Generator Sets Exhaust Manifold
G3500 A3 Engines Engine Pre-Lube Pressure (Low)
G3500 A3 Engines ECM Output Circuit (Prelubrication Oil Pump)
C1.5 and C2.2 Generator Sets Engine Warm-up
C1.5 and C2.2 Generator Sets Stopping the Engine
3054E Industrial Engine Inlet and Exhaust Valve Springs - Remove and Install
3054E Industrial Engine Inlet and Exhaust Valves - Remove and Install
C13 Engine for Combat and Tactical Vehicles Cooling System
3054E Industrial Engine Inlet and Exhaust Valve Guides - Remove and Install
3044C Industrial Engine Fuel and the Effect from Cold Weather