0111-11 Very Low Coolant Level (62)
产生此代码的情况:
发动机控制模块 (ECM) 检测到以下情况:
- 冷却液液位极低超过 30 秒。
- "冷却液液位传感器"被设定为 "4-针式"或 "2-线式浮子传感器"。
- 发动机至少已运转 30 秒钟。
系统响应:
ECM 将记录诊断代码并触发快照。 该诊断代码为激活状态的同时,检查发动机指示灯亮起。 在卡特彼勒电子技师 (ET) 中,在 "发动机冷却液液位"状态的旁边 ECM 将会显示 "低"。
注: 如果安装了冷却液液位过低指示灯,点亮的是这个指示灯而非报警灯。
清除此诊断代码需要工厂密码。
发动机额定功率将以每秒 1% 的速度减少 35%。 最高车速被限制在 72 km/h (45 mph)。
注: 如果 "发动机监测"被设为 停机,当此诊断代码变为激活状态 30 秒后发动机将会停机。
测试步骤 1. 检查冷却液液位
- 检查发动机冷却液液位。 请参阅操作和保养手册,了解更多资料。
预期结果:
发动机冷却液正常。
结果:
- 正常 - 发动机冷却液正常。
修复: 确认冷却液液位传感器的安装是否正确。
停止
- 异常 - 发动机冷却液过低。
修复: 向发动机中添加冷却液。 请参阅操作和保养手册,了解更多资料。
继续进行测试步骤 2。
测试步骤 2. 检查冷却系统有无泄漏
- 检查发动机冷却液有无泄漏。
- 检查发动机机油中有无冷却液。
预期结果:
没有泄漏。 发动机机油中没有冷却液。
结果:
- 正常 - 发动机没有损失任何冷却液。
修复: 确保发动机冷却液液位正常。运行发动机,直至发动机达到正常工作温度。发动机停机,使发动机冷却下来。再次检查发动机冷却液液位。 如果冷却液液位过低,添加更多的发动机冷却液。
停止
- 异常 - 发动机正在泄漏冷却液或发动机机油中有冷却液。
修复: 修理泄漏。核实修理后故障排除。
停止
Caterpillar Information System:
3516B HD Generator Set Generator Set Lifting
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines 0111-02 Coolant Level signal invalid (12)
G3600 Engines Engine Oil Lines - Electrohydraulic System
C9 Urban Transit Bus Engine Fuel System - Prime
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines 0111-01 Low Coolant Level Warning (62)
3054E Industrial Engine Air Compressor Idler Gear - Remove and Install
320B, 320B L and 320B N Excavators Final Drive Oil Sample - Obtain
C1.5 and C2.2 Generator Sets Fuel System - Prime
3054E Industrial Engine Crankshaft Timing Ring - Remove and Install
2002/12/01 The Color of Certain O-Ring Seals Is Changing {7555}
2003/01/01 The Color of Certain O-Ring Seals Is Changing {7555}
C9 Urban Transit Bus Engine Cylinder Head Grounding Stud - Inspect/Clean/Tighten
C7 and C9 On-Highway Engines 0173-11 Very High Exhaust Gas Temperature Derate
C9 Urban Transit Bus Engine Fuel System Water Separator - Drain
3126E Engine for Combat and Tactical Vehicles System Overview
C11, C13 and C15 On-highway Engines 0100-01 Low Oil Pressure Warning (46)
C11, C13 and C15 On-highway Engines 0100-11 Very Low Oil Pressure (46)
3512B Marine Auxiliary Engine Air Inlet and Exhaust Lines
3054E Industrial Engine Accessory Drive - Remove and Install
3126B Marine Engines Engine Will Not Crank
C1.5 and C2.2 Generator Sets Alternator Belt - Inspect/Adjust/Replace
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Battery or Battery Cable - Disconnect
3126B and 3126E On-highway Engines 0071-00 Idle Shutdown Override (01)
3126B and 3126E On-highway Engines 0071-01 Idle Shutdown (47)