 |
|
Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact the skin. |
Note: The location of the oil level gauge and the oil filler cap will vary with the truck model.
| |
| Illustration 1 | g00622328 |
|
(1) Oil level gauge
(2) Oil filler cap | |
| |
| Illustration 2 | g00110310 |
|
(Y) "ADD" mark
(X) "FULL" mark | |
| NOTICE |
|---|
|
Perform this maintenance with the engine stopped. |
- Maintain the oil level between "ADD" mark (Y) and "FULL" mark (X) on oil level gauge (1). Do not fill the crankcase above "FULL" mark (X).
Show/hide table
NOTICE Engine damage can occur if the crankcase is filled above the "FULL" mark on the oil level gauge (dipstick).
An overfull crankcase can enable the crankshaft to dip into the oil. This will reduce the power that is developed and also force air bubbles into the oil. These bubbles (foam) can cause the following problems: reduction of the oil's ability to lubricate, reduction of oil pressure, inadequate cooling of the pistons, oil blowing out of the crankcase breathers and excessive oil consumption.
Excessive oil consumption will enable deposits to form on the pistons and in the combustion chamber. Deposits in the combustion chamber lead to the following problems: guttering of the valves, packing of carbon under the piston rings and wear of the cylinder liner.
If the oil level is above the "FULL" mark on the oil level gauge, drain some of the oil immediately.
- Remove oil filler cap (2) and add oil, if necessary. For the correct oil to use, see this Operation and Maintenance Manual, "Engine Oil" topic (Maintenance Section). Do not fill the crankcase above "FULL" mark (X) on the oil level gauge. Clean the oil filler cap. Install the oil filler cap.
- Record the amount of oil that is added. For the next oil sample and analysis, include the total amount of oil that has been added since the previous sample. This will help to provide the most accurate oil analysis.