MID 033 - CID 0320 - FMI 08 Engine Speed/Timing signal abnormal
Conditions Which Generate This Code:
The slave Electronic Control Module (ECM) must be powered for at least one second. The engine speed is greater than 150 rpm. One of the following two conditions occurs:
- An invalid pattern for the timing reference gear is detected. For example, reverse rotation is detected.
- The pattern for the timing reference gear is lost for less than one second.
System Response:
If the engine is running, the ignition signals stop. The shutdown output is activated. The code is logged.
If the engine is running, the engine will be shut down. If the engine is not running, the engine will not start.
Test Step 1. Perform the following diagnostic procedure: Engine Speed/Timing Sensor
Results:
- OK - STOP
Caterpillar Information System:
G3520B Engines MID 033 - CID 0320 - FMI 03 Speed/Timing Sensor short to +batt
3054E Industrial Engine Piston and Rings
797 and 797B Off-Highway Truck Power Train Electronic Control System Machine Speed Correction
Rework Instruction for Transformers for G3400C Engines with Tall Cylinder Heads{1409, 1550, 1561} Rework Instruction for Transformers for G3400C Engines with Tall Cylinder Heads{1409, 1550, 1561}
Rework Instruction for Transformers that are approved by the Canadian Standards Association (CSA) for G3400C Engines with Tall Cylinder Heads{1550, 1561} Rework Instruction for Transformers that are approved by the Canadian Standards Association (CSA) for G3400C Engines with Tall Cylinder Heads{1550, 1561}
3054E Industrial Engine Connecting Rod - For Use With Steel Crankshaft
2002/08/01 A New Rubber Boot Is Available To Help Protect The Actuator Shafts In The Hydrax System {1716}
Installation of the Caterpillar Ignition System (CIS) on G3612 and G3616 Engines Installation of the Caterpillar Ignition System (CIS) on G3612 and G3616 Engines
EMCPII+ for Gas Engines Fault Identification
EMCPII+ for Gas Engines Service Tools
Power Module Switchgear (Low Voltage and Medium Voltage) Maintenance Interval Schedule
797F Off-Highway Truck Steering System Pressure Switches
C9 Marine Auxiliary and Generator Set Engines Engine Oil Level Gauge - Calibrate
C-18 Truck Engines Model View Illustrations
C-18 Truck Engines Engine Description
C-18 Truck Engines Sensors and Electrical Components
SR4 HV and SR4B HV Generators Bearing - Lubricate
C-15 Truck Engine Exhaust Manifold
C-18 Truck Engines Engine Oil Level - Check
C-18 Truck Engines Engine Oil Level Gauge - Calibrate
C-18 Truck Engines Engine Oil and Filter - Change
C-18 Truck Engines Fuel System - Prime
3406C Industrial Engine Fuel System Secondary Filter - Replace
3054E Industrial Engine Connecting Rod Bearing Journal - Steel Crankshaft