Cylinder Liner
Show/hide table
Illustration 1 | g00288159 |
The following steps are for installing the cylinder liner into the cylinder block.
- Apply 5P-3975 Rubber Lubricant on the surfaces of the cylinder liner bore. Apply 5P-3975 Rubber Lubricant on the rubber seals on the lower part of the cylinder liner.
- Put the filler band completely in clean engine oil for a moment.
- Install the filler band (3) in the groove under the liner flange without delay.
- Install the liner in the bore immediately, before the filler band expands.
(1) Bore in new liner ... 137.185 ± 0.025 mm (5.4010 ± 0.0010 inch)
(2) Thickness of flange on liner ... 8.890 ± 0.020 mm (0.3500 ± 0.0008 inch)
The minimum thickness of the part that can be used again is the following value. ... 8.870 mm (0.3492 inch)
(3) Filler band
Note: Refer to Guideline For Reusable Parts, SEBF8068, "Cylinder Liners" for more information. Also, refer to Testing and Adjusting, "Cylinder Liner - Projection" for the procedure for inspecting the projection of the cylinder liners.
Caterpillar Information System:
C-15 Truck Engine Cylinder Block
3126E Truck Engine Cylinder Head
C-15 Truck Engine Camshaft
G3516B Engines ECM Output Circuit (Fuel Control)
3524B Engines for Off-Highway Trucks Engine Will Not Crank
C-15 Truck Engine Cylinder Head Valves
3524B Engine for Caterpillar Built Machines Engine Oil Filter Base - Install
G3516B Engines MID 036 - CID 1759 - FMI 03 Exhaust Back Pressure Sensor open/short to +batt
G3516B Engines MID 036 - CID 1758 - FMI 08 Specific Humidity Sensor signal abnormal
G3516B Engines MID 036 - CID 1758 - FMI 03 Specific Humidity Sensor open/short to +batt
C-15 Truck Engine Fuel Transfer Pump
C-15 Truck Engine Engine Design
C-15 Truck Engine Piston and Rings
3056E Industrial Engine Fuel System - Prime
3056E Industrial Engine Fuel System Pressure - Test
3056E Industrial Engine Engine Oil Cooler - Inspect
3524B Engine for Caterpillar Built Machines Engine Oil Filter Base - Disassemble
SR4 HV and SR4B HV Generators Generator - Dry
3056E Industrial Engine Fuel Injection Nozzle - Test
Marine Monitoring System II Engine Control Panel
3524B Engine for Caterpillar Built Machines Engine Oil Filter Base - Assemble
Marine Monitoring System II Configuration
C-15 Truck Engine Electrical Ground Stud
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Fuel Transfer Pump - Remove