Turbocharger
Show/hide table
Illustration 1 | g00976435 |
(1) Bolt
- Torque ...
40 ± 2 N·m (30 ± 1 lb ft)
(2) Clamp bolt
Use the following procedure to tighten the clamp bolts:
- Tighten eight bolts.
Torque ...
40 ± 2 N·m (30 ± 1 lb ft) - Tap the clamps lightly around the entire circumference.
- Tighten eight bolts again.
Torque ...
40 ± 2 N·m (30 ± 1 lb ft)
(3) Exhaust seal
Install the two exhaust seals so that the breaks in each ring are separated by approximately 45 degrees.
Caterpillar Information System:
G3500B Engines Water Pump - Aftercooler
3056E Industrial Engine Flywheel
3524B Engines for Off-Highway Trucks E100 Low Engine Oil Pressure Warning
Electronic Modular Control Panel II+ (EMCP II+) Starting Motor Remains Engaged (for EUI and PEEC Engines)
K65-12B Voltage Regulator Electrical
Electronic Modular Control Panel II+ (EMCP II+) System Communication Module (Customer)
Electronic Modular Control Panel II+ (EMCP II+) Synchronizing Lights Module
Electronic Modular Control Panel II+ (EMCP II+) Relay Driver Module
C18 Marine Auxiliary Engine Model View Illustrations
G3500 Generator Sets Voltage Regulators
Electronic Modular Control Panel II+ (EMCP II+) Diagnostic Codes
Electronic Modular Control Panel II+ (EMCP II+) Engine Setpoint Verification OP9
3412E, C30 and C32 Marine Engines Turbocharger Outlet Pressure Sensor - Remove and Install
3412E, C30 and C32 Marine Engines Engine Speed/Timing Sensor Circuit - Test
K65-12B Voltage Regulator General Information
PMG3516 Power Module Rotating Rectifier - Test
3412E, C30 and C32 Marine Engines Engine Synchronize Switch Circuit - Test
K65-12B Voltage Regulator Manual Voltage Control
K65-12B Voltage Regulator Voltage Droop Control
3056E Industrial Engine Air Inlet Heater
3056E Industrial Engine Electronic Control Module
3412E, C30 and C32 Marine Engines Unit Injector Hydraulic Pump - Remove
K65-12B Voltage Regulator General Information
K65-12B Voltage Regulator Low Voltage