Electronic Control Module
Show/hide table
Illustration 1 | g00884768 |
(1) Tighten the bolt to the following torque. ...
(2) Tighten the allen head screw to the following torque. ...
Tighten the 3 bolts that hold the machine interface connector (not shown) to the bracket, to the following torque. ...
Tighten the retaining screw that holds the machine interface connector to the electronic control connector (not shown) to the following torque. ...
Caterpillar Information System:
3056E Industrial Engine Air Inlet Heater
K65-12B Voltage Regulator Voltage Droop Control
K65-12B Voltage Regulator Manual Voltage Control
3412E, C30 and C32 Marine Engines Engine Synchronize Switch Circuit - Test
PMG3516 Power Module Rotating Rectifier - Test
K65-12B Voltage Regulator General Information
3412E, C30 and C32 Marine Engines Engine Speed/Timing Sensor Circuit - Test
3412E, C30 and C32 Marine Engines Turbocharger Outlet Pressure Sensor - Remove and Install
G3500B Engines Turbocharger
G3500B Engines Water Pump - Aftercooler
3056E Industrial Engine Flywheel
3524B Engines for Off-Highway Trucks E100 Low Engine Oil Pressure Warning
3412E, C30 and C32 Marine Engines Unit Injector Hydraulic Pump - Remove
K65-12B Voltage Regulator General Information
K65-12B Voltage Regulator Low Voltage
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0190 - FMI 02
K65-12B Voltage Regulator High Voltage
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0190 - FMI 03
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0269 - FMI 03
3412E, C30 and C32 Marine Engines Unit Injector Hydraulic Pump - Install
3412E, C30 and C32 Marine Engines Switch Circuits - Test
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0334 - FMI 04 (for EUI Engines)
K65-12B Voltage Regulator Unstable Voltage
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0441 - FMI 12 (for MUI Engines)