Water Pump - Aftercooler
Show/hide table
Illustration 1 | g00955867 |
(1) Lip type seal
Do not lubricate the sealing lip.
(2) Rubber seal
(3) Ceramic ring
(4) Seal assembly
(5) Spring
Use the following procedure to install the rubber seal, the ceramic ring, the seal assembly, and the spring:
- Use the seal installation tool with hand pressure to install the rubber seal and the ceramic ring as a unit into the housing bore. Orient the polished face of the ceramic ring toward the carbon seal assembly that will be installed next.
Note: Only use clean water to lubricate the parts.
Note: The seal installation tool is part of the replacement seal assembly.
- Remove the spring from the seal assembly.
- Use the seal installation tool with hand pressure to install the seal assembly onto the shaft until the seal faces make light contact.
- Install the spring onto the seal assembly.
(6) O-ring seal
Lubricate the bore for the O-ring seal with engine oil or glycerin or clean water.
Caterpillar Information System:
3056E Industrial Engine Flywheel
3524B Engines for Off-Highway Trucks E100 Low Engine Oil Pressure Warning
Electronic Modular Control Panel II+ (EMCP II+) Starting Motor Remains Engaged (for EUI and PEEC Engines)
K65-12B Voltage Regulator Electrical
Electronic Modular Control Panel II+ (EMCP II+) System Communication Module (Customer)
Electronic Modular Control Panel II+ (EMCP II+) Synchronizing Lights Module
Electronic Modular Control Panel II+ (EMCP II+) Relay Driver Module
C18 Marine Auxiliary Engine Model View Illustrations
G3500 Generator Sets Voltage Regulators
Electronic Modular Control Panel II+ (EMCP II+) Diagnostic Codes
Electronic Modular Control Panel II+ (EMCP II+) Engine Setpoint Verification OP9
3512 and 3516 EUI Engines and 784B, 785B, 789B and 793B Off-Highway Truck/Tractors Water Pump
G3500B Engines Turbocharger
3412E, C30 and C32 Marine Engines Turbocharger Outlet Pressure Sensor - Remove and Install
3412E, C30 and C32 Marine Engines Engine Speed/Timing Sensor Circuit - Test
K65-12B Voltage Regulator General Information
PMG3516 Power Module Rotating Rectifier - Test
3412E, C30 and C32 Marine Engines Engine Synchronize Switch Circuit - Test
K65-12B Voltage Regulator Manual Voltage Control
K65-12B Voltage Regulator Voltage Droop Control
3056E Industrial Engine Air Inlet Heater
3056E Industrial Engine Electronic Control Module
3412E, C30 and C32 Marine Engines Unit Injector Hydraulic Pump - Remove
K65-12B Voltage Regulator General Information