Cylinder Head Grounding Stud - Inspect/Clean/Tighten
Show/hide table
Illustration 1 | g00880732 |
(1) Primary location of the cylinder head ground stud on C-10 and C-12 engines (2) Alternate location of the ground stud on C-10 and C-12 engines |
Show/hide table
Illustration 2 | g00880739 |
(3) Location of the cylinder head ground stud on 3406E engines |
Inspect the OEM vehicle wiring harness for the following conditions:
- Connections that are loose or disconnected
- Mounting hardware that is missing
- Insulation that is chafed or cut
- Wires that are bare
The cylinder head grounding stud must have a wire ground to the battery. Tighten the cylinder head grounding stud at every oil change. Ground wires and straps should be combined at engine grounds. All grounds should be tight and free of corrosion.
- Clean the cylinder head grounding stud and the terminals for the cylinder head ground strap with a clean cloth.
- If the connections are corroded, clean the connections with a solution of baking soda and water.
- Keep the cylinder head grounding stud and the strap clean and coated with MPGM grease or petroleum jelly.
Caterpillar Information System:
2002/08/01 The New 216-7919 Gasket Is Available {1071}
3500 Generator Set Engines Fuel Shutoff Solenoid
3412E, C30 and C32 Marine Engines Flash Codes
3500 Engines Electrical Gauge - Test - Water Temperature
2002/04/01 Correction To Disassembly And Assembly, RENR1333-01, "3618 Engine" {1102}
3406E, C-10 and C-12 Truck Engines Engine Operation
3406E, C-10 and C-12 Truck Engines Starting the Engine
3126E Truck Engine Exhaust Particulate Filter - Assemble
3406E, C-10 and C-12 Truck Engines Engine Operation with Intermittent Diagnostic Codes
3406E, C-10 and C-12 Truck Engines Engine Operation with Active Diagnostic Codes
797B Off-Highway Truck Hydraulic System Pad Assembly (Truck Body) - Install and Adjust
3500 Generator Set Engines Air Shutoff Solenoid
3406E, C-10 and C-12 Truck Engines Engine Oil Level - Check
3406E, C-10 and C-12 Truck Engines Engine Oil Level Gauge - Calibrate
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Injection Actuation Pressure Sensor - Test
3406E, C-10 and C-12 Truck Engines Engine Oil and Filter - Change
3412E, C30 and C32 Marine Engines CID 0177 FMI 03 Transmission Oil Temperature open/short to +batt
3412E, C30 and C32 Marine Engines CID 0177 FMI 04 Transmission Oil Temperature short to ground
3500 Industrial Engine Attachments Electrical Gauge - Test - Engine Oil Pressure
2002/04/01 A New Cylinder Liner Is Available {1216}
G3500B Engines Cooling System - Power Module
3406E, C-10 and C-12 Truck Engines Fuel System - Prime
3406E, C-10 and C-12 Truck Engines Fuel System Secondary Filter - Replace
C-10, C-12 and C-15 On-Highway Engines Model View Illustrations