Maintenance Interval Schedule
Note: All safety information, warnings, and instructions must be read and understood before you perform any operation or any maintenance procedure.
Undercarriage - Check
Before each consecutive interval is performed, all of the maintenance requirements from the previous interval must be performed.
When Required
Track Adjustment - AdjustEvery 10 Service Hours or Daily
Track Adjustment - InspectUndercarriage - Check
Initial 250 Service Hours
Final Drive Oil - ChangeEvery 250 Service Hours or Monthly
Final Drive Oil Level - CheckEvery 2000 Service Hours or 1 Year
Final Drive Oil - ChangeCaterpillar Information System:
3408E and 3412E Industrial Engines Low Power/Poor or No Response to Throttle
CIPI UNDERCARRIAGE Arrangements: 9Q-5195, 9Q-5197, 9Q-5198, 9Q-5232, 9Q-5504, 9Q-5643, 9Q-5651, 9Q-5727, 9Q-5728, 9Q-5729, 9Q-5730, 9Q-5731, 9Q-5747, 9Q-5876, 180-4029, and 213-3892 Refill Capacities
3408E and 3412E Industrial Engines Intermittent Low Power or Power Cutout
3408E and 3412E Industrial Engines Intermittent Engine Shutdown
CPT372 Truck Mounted Pumper Hydraulic System Oil and Filter - Change
3126E On-highway Engine PTO Engine RPM Set Speed (Input A and Input B) Circuit - Test
3500 Generator Set Engines Pressure Contactor
CIPI UNDERCARRIAGE Arrangements: 9Q-5195, 9Q-5197, 9Q-5198, 9Q-5232, 9Q-5504, 9Q-5643, 9Q-5651, 9Q-5727, 9Q-5728, 9Q-5729, 9Q-5730, 9Q-5731, 9Q-5747, 9Q-5876, 180-4029, and 213-3892 Final Drive Sun Gear Removal
3500 Generator Set Engines Pressure Contactor
CIPI UNDERCARRIAGE Arrangements: 9Q-5195, 9Q-5197, 9Q-5198, 9Q-5232, 9Q-5504, 9Q-5643, 9Q-5651, 9Q-5727, 9Q-5728, 9Q-5729, 9Q-5730, 9Q-5731, 9Q-5747, 9Q-5876, 180-4029, and 213-3892 Final Drive Ring Gear Removal
2002/02/11 Caterpillar Electronic Technician (Cat ET) 2001B-Service Pack 1 Software Upgrade is Now Available {0785}
3512B Petroleum Engines with the ADEM 2 Electronic Control Module Diagnostic Codes - Flash Codes
3512B Marine Auxiliary Engine Thermocouple Test
CPT372 Truck Mounted Pumper Plate Locations and Film Locations
2002/03/01 A New Flywheel Housing Gasket Is Now Available For Engines With A PTO {1157, 1165}
120H, 12H, 135H, 140H, 143H, 14H, 160H, 163H and 16H Motor Graders Caterpillar Monitoring System Using Caterpillar Electronic Technician to Determine Diagnostic Codes
3126B Engine for Caterpillar Built Machines Air Inlet Heater Circuit - Test
3500 Industrial Engines Woodward UG8 Governor
CIPI UNDERCARRIAGE Arrangements: 9Q-5195, 9Q-5197, 9Q-5198, 9Q-5232, 9Q-5504, 9Q-5643, 9Q-5651, 9Q-5727, 9Q-5728, 9Q-5729, 9Q-5730, 9Q-5731, 9Q-5747, 9Q-5876, 180-4029, and 213-3892 Motor Control (Travel)
CIPI UNDERCARRIAGE Arrangements: 9Q-5195, 9Q-5197, 9Q-5198, 9Q-5232, 9Q-5504, 9Q-5643, 9Q-5651, 9Q-5727, 9Q-5728, 9Q-5729, 9Q-5730, 9Q-5731, 9Q-5747, 9Q-5876, 180-4029, and 213-3892 Travel Motor
385B and 5090B Excavators Excavator Systems Solenoid Valve (Swing Brake) - Assemble
2002/03/01 Correction to Information Regarding the Need for Timing Calibration after Replacing the Engine ECM {1901, 1912, 1912}
385B and 5090B Excavators Excavator Systems Solenoid Valve (Swing Brake) - Disassemble
3126B Marine Engines CID 0320 FMI 02 Speed/Timing Sensor Loss of Signal