3054 and 3056 Engines 520 Generator Set Control Panel Caterpillar


Specification

Usage:

3054 CHN
DC Power Supply (continuous) ... 8.0 VDC to 35 VDC

Cranking Dropouts (providing supply was at least 10 V before dropout and providing supply recovers to 5 V) ... 0 V for 50 ms

Maximum Operating Current (12 V) ... 290 mA

Maximum Operating Current (24 V) ... 210 mA

Maximum Standby Current (12 V) ... 50 mA

Maximum Standby Current (24 V) ... 30 mA

Alternator Input Range ... 15 VAC RMS to 300 VAC RMS

Alternator Input Frequency (at rated engine speed) ... 50 Hz or 60 Hz

Engine Speed Input Range (Clamped by transient voltage transient suppressors) ... 0.5 V to ± 70 V

Engine Speed Input Frequency (at rated engine speed) ... 10 Hz to 10,000 Hz

Start Relay Output (at supply voltage) ... 16 Amp DC

Fuel Relay Output (at supply voltage) ... 16 Amp DC

Programmable Relay Outputs (at supply voltage) ... 5 Amp DC

Length ... 144 mm ( 5.67 in)

Height ... 72 mm ( 2.83 in)

Width ... 118 mm ( 4.67 in)

Note: The dimensions exclude the key switch or the knob.

Charge Fail/Excitation Range ... 0 V to 35 V

Operating Temperature Range ... -30 °C to 55 °C (-22 °F to 131 °F)

Caterpillar Information System:

3054 and 3056 Marine Generator Set Engines Valve Depth - Inspect
3054 and 3056 Engines 520 Generator Set Control Panel Symbols
3126 Truck Engine (Military) Diagnostic Flash Code Retrieval
2001/11/01 Setting the Desired Rated Speed or Emissions Strategy for Generator Sets {1901}
Power Module Switchgear (Low Voltage and Medium Voltage) Manual Parallel Operation
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Air Inlet Shutoff Circuit - Test
120H, 12H, 135H, 140H, 143H, 160H and 163H Motor Graders Electrical Connector - Inspect
Power Module Switchgear (Low Voltage and Medium Voltage) Base Load Operation
Power Module Switchgear (Low Voltage and Medium Voltage) Standby Operation
Power Module Switchgear (Low Voltage and Medium Voltage) General Operation
G3516B Engines MID 036 - CID 1447 - FMI 12 Fuel Metering Sensor Module malfunction
G3516B Engines MID 036 - CID 1446 - FMI 13 Fuel Metering Module calibration required
Power Module Switchgear (Low Voltage and Medium Voltage) Generator Circuit Breaker
3054 and 3056 Engines 520 Generator Set Control Panel Initial Startup Procedure
3126 Truck Engine (Military) Engine Operation
3126 Truck Engine (Military) Maintenance Interval Schedule
3126 Truck Engine (Military) Engine Oil and Filter - Change
3054 and 3056 Marine Generator Set Engines Air Inlet Heater - Test
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply Dry Contact - Configure
SCT673 Truck Mounted PumperPOD Control Panel - Raise/Lower Blender
3126E Truck Engine Turbocharger
3116 Truck Engine Exhaust Brake
3054 and 3056 Marine Generator Set Engines Alternator - Test
3408E and 3412E Industrial Engines Cylinder Block
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.