Rocker Shaft - Assemble
Assembly Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Lubricate all of the components with clean engine oil.
Note: Inspect O-ring seal (8) for wear or for damage. If the O-ring seal is worn or damaged, use a new part for replacement.
- Install adjusting screw (6) and nut (5) to rocker arms (1) and rocker arms (2) .
Show/hide table
 | |
| Illustration 1 | g00842949 |
Show/hide table
 |
Improper assembly of parts that are spring loaded can cause bodily injury. To prevent possible injury, follow the established assembly procedure and wear protective equipment. |
 |
- Position rocker shaft (7) in the end of base (9) .
- Gradually insert rocker shaft (7) and install rocker arm (1) .
- Insert rocker shaft (7) and install rocker arm (2) .
- Slide rocker shaft (7) through washer (3) and spring (4) .
- Repeat Steps 2 through 6 in order to install the remaining components.
End By: Install the rocker shaft and the pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Install".
Caterpillar Information System:
3024C Engine for Caterpillar Built Machines Rocker Shaft - Disassemble
Machine Security System Product Identification Number - Program
3024C Engine for Caterpillar Built Machines Rocker Shaft and Pushrod - Remove
Machine Security System Time - Set
2001/10/01 Commercial Folded Core Radiators Can Be Converted to Multiple Row Module Radiators {1353}
2001/10/01 Improved Troubleshooting Procedures for EMCPII, EMCPII+, and EMCPII+P Annunciators {4490}
Automatic Transfer Switches CTG, CTGD Series Timers
3054 and 3056 Industrial and Generator Set Engines Fuel Injection Nozzles
3054 and 3056 Marine Generator Set Engines Fuel Injection Pump
2001/11/01 A New Rear Housing Assembly is Available {1157}
3408E and 3412E Industrial Engines Coolant Level Sensor Circuit - Test
Power Module Switchgear (Low Voltage and Medium Voltage) Abbreviations
Electronic Modular Control Panel II (EMCP II) General Information
Electronic Modular Control Panel II (EMCP II) Fault Identification
Electronic Modular Control Panel II (EMCP II) Service Tools
3054 and 3056 Engines 520 Generator Set Control Panel General Information
3054 and 3056 Industrial and Generator Set Engines Cylinder Head Valves
3054 and 3056 Industrial and Generator Set Engines Cylinder Head
Electronic Modular Control Panel II (EMCP II) Troubleshooting Diagnostic Codes
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0334 - FMI 04 (for MUI and PEEC Engines)
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0336 - FMI 02
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0441 - FMI 12 (for EUI Engines)
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Flywheel - Remove
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0441 - FMI 12 (for PEEC Engines)