Rocker Shaft - Disassemble
Disassembly Procedure
Start By:
- Remove the rocker shaft and the pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Remove".
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- In order to remove rocker arms (1), rocker arms (2), washers (3), and springs (4) slide rocker shaft (7) from the end of base (9) .
Note: Place an identification mark on each of the components for installation.
Show/hide table
 | |
| Illustration 1 | g00842949 |
Show/hide table
 |
Personal injury can result from being struck by parts propelled by a released spring force. Make sure to wear all necessary protective equipment. Follow the recommended procedure and use all recommended tooling to release the spring force. |
 |
- Remove adjusting screws (6) and nut (5) from rocker arms (1) and rocker arms (2) .
- Inspect all of the components from base (9) for wear or for damage. If any of the components are worn or damaged, use new parts for replacement.
- Inspect O-ring seal (8) for wear or for damage. If the O-ring seal is worn or damaged, use a new part for replacement.
Caterpillar Information System:
Machine Security System Product Identification Number - Program
3024C Engine for Caterpillar Built Machines Rocker Shaft and Pushrod - Remove
Machine Security System Time - Set
2001/10/01 Commercial Folded Core Radiators Can Be Converted to Multiple Row Module Radiators {1353}
2001/10/01 Improved Troubleshooting Procedures for EMCPII, EMCPII+, and EMCPII+P Annunciators {4490}
Automatic Transfer Switches CTG, CTGD Series Timers
3054 and 3056 Industrial and Generator Set Engines Fuel Injection Nozzles
3054 and 3056 Marine Generator Set Engines Fuel Injection Pump
2001/11/01 A New Rear Housing Assembly is Available {1157}
3408E and 3412E Industrial Engines Coolant Level Sensor Circuit - Test
Power Module Switchgear (Low Voltage and Medium Voltage) Abbreviations
2001/11/19 New Protective Caps For Hose Clamps Are Now Available {5057}
3024C Engine for Caterpillar Built Machines Rocker Shaft - Assemble
Electronic Modular Control Panel II (EMCP II) General Information
Electronic Modular Control Panel II (EMCP II) Fault Identification
Electronic Modular Control Panel II (EMCP II) Service Tools
3054 and 3056 Engines 520 Generator Set Control Panel General Information
3054 and 3056 Industrial and Generator Set Engines Cylinder Head Valves
3054 and 3056 Industrial and Generator Set Engines Cylinder Head
Electronic Modular Control Panel II (EMCP II) Troubleshooting Diagnostic Codes
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0334 - FMI 04 (for MUI and PEEC Engines)
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0336 - FMI 02
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0441 - FMI 12 (for EUI Engines)
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Flywheel - Remove