Ether Control System
The ECM automatically injects ether into the air inlet manifold when the following conditions are met.
- The engine speed is between 50 rpm and 400 rpm.
- The jacket water coolant temperature is below 30 °C (86 °F).
The duration of ether injection varies linearly with the jacket water coolant temperature. The duration of ether injection varies within the following range.
- 15 seconds at the maximum temperature of 30 °C (86 °F)
- 130 seconds at the minimum temperature of -50 °C (-58 °F)
The longest duration of ether injection is 130 seconds even if the jacket water coolant temperature is below -50 °C (-58 °F).
A switch input is provided to the ECM in order to allow the operator to manually inject ether. Manual ether injection can occur when the following conditions are met.
- The ether switch is in the manual position.
- The engine speed is above 50 rpm.
- The jacket water coolant temperature is below 30 °C (86 °F).
Note: If the engine is equipped with an ether aid system, then the "Configuration Parameter" for "Ether Aid" must be programmed "ON".
Caterpillar Information System:
G3500 Engines Gas Pressure
G3500 Engines Carburetor - Adjust
G3500 Engines General Information (Fuel System)
C-10, C-12, C-15 and C-16 Industrial Engines E100 Low Engine Oil Pressure Warning
C-10, C-12, C-15 and C-16 Industrial Engines E040 Low Engine Oil Pressure Shutdown
G3500 Engines Measuring Engine Oil Pressure
3512B Marine Auxiliary Engine Emergency Stop Switch
G3408 and G3412 Engines Gas Engine Ignition
G3408C and G3412C Engines Related Components
3512B Marine Auxiliary Engine Electrical Power Supply
G3500 Engines Camshaft
3512B Marine Auxiliary Engine ECM/Personality Module
G3500 Engines Crankshaft Position for Valve Lash Setting
3034 Marine Engine - Installation Guide Engine Room Ventilation
3034 Marine Engine - Installation Guide Engine Cooling System
3512B Marine Auxiliary Engine Emergency Stop Switch (Remote)
3034 Industrial Engine Fuel System - Prime
G3500 Engines Measuring Inlet Manifold Temperature
3512B Marine Auxiliary Engine Engine Control Switch (ECS)
G3500 Engines Ignition Transformer
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply System Controller Board - Remove and Install
G3500 Engines Engine Speed/Timing Sensor
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply Fan Monitor Board - Remove and Install
G3500 Engines Detonation Sensor