Engine Oil Filter Base - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position the gasket and engine oil filter base (3) over the engine oil cooler. Install the bolts that hold engine oil filter base (3) to the cylinder block. Tighten the bolts according to the following procedure:
- Tighten Bolt (1) through Bolt (15) in a numerical sequence to a torque of 15 N·m (11 lb ft).
- Tighten Bolt (1) through Bolt (15) in a numerical sequence to a torque of 28 N·m (21 lb ft).
Show/hide table
Illustration 1 | g01026328 |
Show/hide table
Illustration 2 | g01185803 |
- Connect tube assembly (2) to the elbow assembly.
- Install oil filter assembly (1) . Follow the instructions with the oil filter assembly for the correct installation.
Caterpillar Information System:
G3516B and G3520B Generator Set Engines Water Temperature Regulators - Install
3054 and 3056 Industrial and Generator Set Engines Aftercooler - Test
3054 and 3056 Industrial and Generator Set Engines Turbocharger - Inspect
TA19-M2WD and TA19-M4WD (Delta) Agricultural Transmission Power Train Electronic Control System Sensor Signal Voltage
3054 Engine Gear Group (Front) - Time
Exhaust Temperature Scanner Start-up Sequence
3126E and 3126B Commercial and Truck Engines Information Plate
3512B HD SR500 Generator Sets Reference Information
3406E and 3456 Industrial Engines Aftercooler - Test
Exhaust Temperature Scanner Keypad - Overview
3126E and 3126B Commercial and Truck Engines Serial Number Plate
3516B Power Package Reference Material
Exhaust Temperature Scanner Setpoints
3046 Engine for Caterpillar Built Machines Increased Engine Oil Temperature - Inspect
3054 and 3056 Industrial and Generator Set Engines Valve Depth - Inspect
C-15 and C-16 Industrial Engines Reference Numbers
Exhaust Temperature Scanner System Configuration Parameters (Scanner)
C-15 and C-16 Industrial Engines Customer Specified Parameters
3054 and 3056 Industrial and Generator Set Engines Valve Guide - Inspect
3054 and 3056 Marine Generator Set Engines Heat Exchanger - Test
3126B Industrial Engines Sensors and Electrical Connectors
Exhaust Temperature Scanner Alarm Description
2000/12/01 A New ADEM 2000 ECM is Now Available {1901}
3054 Engine Piston Height - Inspect