| NOTICE |
|---|
Do not utilize any type of impact or automatic wrench to install the bolts which retain the locking bar. The bolts which retain the locking bar must be properly torqued. Tighten the bolts to the exact torque specifications and do not over torque the bolts during installation. Excessive torque applied to the bolts will result in damage in the thread root which will lead to failure of the bolt during operation. High shock-loads transmitted through the cylinder rod will result in a fatigue fracture of the bolt as a result of this excessive torque. As a result, a catastrophic failure of the cylinder may occur. |
 | |
| Illustration 1 | g02212213 |
This cylinder is a double acting cylinder.
Cylinder stroke ... 858 mm (33.78 inch)
Operating pressure ... 35000 kPa (5076 psi)
(1) Diameter of the piston ... 319.4 mm (12.5748 inch)
(2) Bore in the cylinder ... 320 mm (12.5984 inch)
(3) Diameter of the rod ... 199.914 ± 0.036 mm (7.8706 ± 0.0014 inch)
(4) Outer diameter of the bushings ... 195.137 ± 0.015 mm (7.6825 ± 0.0006 inch)
Inner diameter of the bushings ... 170.28 ± 0.05 mm (6.7039 ± 0.0020 inch)
(5) Outer diameter of the bushings ... 224.86 ± 0.02 mm (8.8527 ± 0.0008 inch)
Inner diameter of the bushings ... 199.86 ± 0.02 mm (7.8685 ± 0.0008 inch)
(6) Torque on the bolts ... 700 N·m (516 lb ft)
Apply 9S-3263 Thread Lock Compound to the threads of 27 bolts (6) .
(7) Apply "Loctite 648" to the threads.