Cooling System Coolant Level - Check
Check the coolant level when the engine is stopped and cool.
- Observe the coolant level in the coolant recovery tank. Maintain the coolant level to "COLD FULL" mark on the coolant recovery tank.
Show/hide table
Pressurized System: Hot coolant can cause serious burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure.
- Loosen filler cap slowly in order to relieve any pressure. Remove the filler cap.
- Pour the proper coolant mixture into the tank. Refer to the Operation and Maintenance Manual, "Refill Capacities and Recommendations" for information on the correct mixture and type of coolant. Refer to the Operation and Maintenance Manual, "Refill Capacities and Recommendations" for the cooling system capacity. Do not fill the coolant recovery tank above "COLD FULL" mark.
Show/hide table
Illustration 1 g00103639 - Clean filler cap and the receptacle. Reinstall the filler cap and inspect the cooling system for leaks.
Note: The coolant will expand as the coolant heats up during normal engine operation. The additional volume will be forced into the coolant recovery tank during engine operation. When the engine is stopped and cool, the coolant will return to the engine.
Caterpillar Information System:
3054, 3054B and 3056 Marine Engines Cooling System Coolant (ELC) - Change
3054, 3054B and 3056 Marine Engines Aftercooler - Remove
G3304 and G3306 Engines Compression
G3408C and G3412C Engines Engine Crankcase Pressure (Blowby) - Test
UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Symbols
3126B and 3126E On-highway Engines Injection Actuation Pressure Control Valve - Install
3126B and 3126E On-highway Engines Injection Actuation Pressure Control Valve - Assemble
3126B and 3126E On-highway Engines Injection Actuation Pressure Control Valve - Disassemble
3126B and 3126E On-highway Engines Injection Actuation Pressure Control Valve - Remove
3126B and 3126E On-highway Engines Fuel Filter Base - Install
3126B and 3126E On-highway Engines Fuel Filter Base - Remove
3054, 3054B and 3056 Marine Engines Cooling System Coolant (DEAC) - Change
G3304 and G3306 Engines Connecting Rod - Inspect
G3304 and G3306 Engines Connecting Rod Bearings - Inspect
C-9 Engines for Caterpillar Built Machines Connecting Rod
C-10, C-12, C-15 and C-16 Industrial Engines Maintenance Due Lamp Circuit - Test
3054, 3054B and 3056 Marine Engines Engine Air Cleaner Element - Clean/Replace
G3304 and G3306 Engines Vibration Damper - Check
3054, 3054B and 3056 Marine Engines Engine Oil Level - Check
UPS 250 and UPS 300 Uninterruptible Power Supplies Site Preparation
G3304 and G3306 Engines Pressure Regulating Valve
G3304 and G3306 Engines Lubrication
C-10, C-12, C-15 and C-16 Industrial Engines Warning Lamp Circuit - Test
G3406 Engine Exhaust Bypass Valve