0042-11 Injection Actuation Pressure output fault
Conditions Which Generate This Code:
The ECM detected one of the following conditions:
- Open circuit
- Short to ground
- Short to + battery
- Short across the solenoid when the engine is running.
System Response:
Electronic System Response The ECM will cycle the control valve for the injection actuation system on and off. The ECM will cycle the control valve several times in a second when the engine is running. The fault is active.
Engine Response The engine will stop running if the signal line for the control valve for the injection actuation system is shorted to ground.
If the pressure sensor common for the control valve is shorted to ground, the following conditions may exist:
- The engine may continue to run.
- The idle may be unstable.
Test Step 1. Perform the following diagnostic procedure: Injection Actuation Pressure Control Valve Circuit - Test
Results:
- OK - STOP
Caterpillar Information System:
657E Wheel Tractor-Scraper Hydraulic System Pressure Reducing Valve (Implement Pilot)
325D and 329D Excavators Work Tool Control (Two-Way Flow) - If Equipped
G3408 and G3412 Engines Flywheel
3126B and 3126E On-highway Engines 0253-02 Check Customer or System Parameters (56)
2000/08/01 Additional Serviceable Components Are Available For The Caterpillar Ignition System (CIS) {1550}
3126B Engine for Caterpillar Built Machines CID 0091 FMI 08 Throttle Position signal abnormal
CPT372 Truck Mounted Pumper Reference Information
3126B and 3126E On-highway Engines 0190-02 Primary Engine Speed Loss of Signal (34)
3126B and 3126E On-highway Engines 0253-14 Truck Manufacturer Parameter Not Programed
JF Series Starting Motor General Information
3126B and 3126E On-highway Engines 0190-11 Primary Engine Speed no pattern (34)
3406E, C-10 and C-12 Truck Engines Compression Brake
3406E Truck Engine Electric Starting Motor
2000/09/01 Optional Oil Mist Detector Groups Are Available {1336}
SPS342 Skid Mounted Pumper Cold Weather Starting
3406E Truck Engine Electrical Ground Stud
2000/08/01 Software Available For Programming Allen-Bradley Programmable Logic Controller (PLC) {1000, 7620}
G3406 Engines Stub Shaft (Rear)
Oil Mist Detectors Commissioning Procedure
G3408C and G3412C Engines Engine Design
G3408C and G3412C Engines Gas Engine Ignition
C9 On-highway Engine Engine Control Module
SPT342 Truck Mounted Pumper Junction Box
G3408C and G3412C Engines Gas Pressure Regulator